ERF‐HR4132A‐F Reference Manual FOR TIRIS PROXIMITY TAG CID/Data Read/Write Controller VERSION: 1.00 HEART TECH ENTERPRISE CO., LTD.
Introduction : Thank you for purchasing the ERF‐HR4132A‐F CIDRW System. Please observe the following points when operating the ERF‐HR4132A‐F: • Please read and understand the content of this manual before using the system. • After reading this manual, store it in a handy location for easy reference whenever necessary. FITTINGS Core : King-Core KCF-65-B x 1 Precautions in using the product : READ AND UNDERSTAND THIS DOCUMENT Please read and understand this document before using the products.
The following are some examples of applications for which particular attention must be given. This is not intended to be an exhaustive list of all possible uses of the products, nor is it intended to imply that the uses listed may be suitable for the products: • Outdoor use, uses involving potential chemical contamination or electrical interference, or conditions or uses not described in this document.
Connect the equipment to an outlet to a circuit other than the one to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for assistance. FCC ID : 2AB67-ERF-HR4132A-F Compliance with : FCC Code of Fedral Requlations,Part 15 Subpart C, Section §15.205 FCC Code of Fedral Requlations,Part 15 Subpart C, Section §15.209 WARNING Changes or modifications not expressly approved by the party responsible for compliance may void the user's authority to operate the equipment.
Installation : CID/Data Read/Write Controller Mount the CIDRW Controller with the two M3 - M4 screws . Note: Tighten the M3 - M4 screws with a torque not exceeding 1.2 N·m. Do not apply organic solvents used with screw locking agents at the locations where the screws are inserted. Antenna Stick antenna HEART TECH ENTERPRISE CO., LTD.
Rectangular antenna Note:Mount with the two M4 plastic screws . Champ Core Installation Instructions HEART TECH ENTERPRISE CO., LTD.
Transmission Area (information only): Antenna : Stick antenna Tag : TEXAS INSTRUMENTS 32mm Glass Transponder part number RI‐TRP‐DR2B The transmission area diagram going through the center of the antenna and indicated on a flat surface vertical to the antenna surface is as indicated below. X Measurement benchmark Y 4.5mm 6mm HEART TECH ENTERPRISE CO., LTD.
Antenna : Rectangular antenna Tag : TEXAS INSTRUMENTS 32mm Glass Transponder part number RI‐TRP‐DR2B The transmission area diagram going through the center of the antenna and indicated on a flat surface vertical to the antenna surface is as indicated below. Y Measurement benchmark X Measurement schematic 6mm Stainless plate : Thickness 3mm Stainless plate : Thickness 3mm HEART TECH ENTERPRISE CO., LTD.
General specifications: Characteristic Specification Comment Supply Voltage Range DC 10 ~ 30V Supplied from the power terminals Current consumption @12VDC Average 50mA ; Peak 160mA Approx. 2A max, with rush current Transmitting Radio Frequency Typical 134.
Remote I/O port pin arrangement: The Remote I/O Target type: Hand Reader and Controller I/O Panel Symbol Pin No.
system completed or the CID Read/Write controller receives a new command from Host system, the Left‐LED and Right‐LED will be turned off. However the feedback time span of the LED turn on should not be less than 1 second. (4) When the CID/data is accessed successfully, the CID Read/Write controller begins to request the Host system for ready to send CID/data, the Left‐LED and Right‐LED is turned on 500 ms and off 500 ms until the CID/data is transmitted to the Host system completed.