Assembly Manual

January 26, 2021
Heads Up Goggles, LLC
651 N BROAD ST
STE 205 #4247
MIDDLETOWN, DE 19709
Heads Up Goggles LLC manual for assembly and labeling of REKKIE SKI-1 module RFM95C
This manual provides instructions on installing the RFM95C module (FCC ID: 2A4BT-SK01) into the REKKIE SKI-1 goggle
product.
After soldering the module on the PCB but before installing the PCB into the enclosure, a label (shown below) must be
applied to the product. This process of incorporating a radio module into a final product and being able to apply the
certification numbers (approvals) to the final product means that the product is in adherence to all relevant
requirements and restrictions, including but not limited to selection of proper antennas, antenna-to-user and collocation
separation distances, manual statements and labeling requirements.
Module Product Label
Our label includes the following information:
FCC ID: (if not clearly displayed on the chip)
2A4BT-SK01
See below for how the label is applied to the module. Note that it covers up the prior owner FCC ID number.
Prior to final assembly of the lid enclosure, all of the PCB assemblies containing an RFM95C chip must be inspected for
quality control to confirm that the label has been properly affixed.
WARNING: The Federal Communications Commission warns that changes or modifications of the radio module within
this device not expressly approved by Heads Up Goggles LLC could void the user’s authority to operate the
equipment. This statement must also be included in the final product manual.