User Manual

IMPACT
MANUAL
HIT
®
Impact
Device
1 x CR2032
Battery
+
-
EN: Included in pack: 1 x CR2032 Battery, 1 x IMPACT
Device
EN: To open Device use a finger nail to prise device
seal apart.
EN: Battery placed on underside of device board.
Providing power to the unit.
Sensor Board
underside
EN: Push device back together with finger and
forethumb (
you may need to use both hands). The device is
sealed when the top cap ‘clicks’ into place with the
bottom cap. The device is now sealed and water
resistance.
EN: To turn on device, push and hold the button
segment of the IMPACT device for 1 second. The device
will flash green then flash consistently to confirm
ready state.
EN: Open the HIT App on your android or iOS
smartphone or tablet and follow the steps to connect
your device via bluetooth. Rename it to your unique ID
and click on Individual play to start recording.
08:42
HIT
®
EN: Device will continue to record and store IMPACT
data until you stop recording on app or turn off
device. When device flashes RED the device has
registered a G-Force impact over the traffic light
threshold.
EN: The App will ping a notification and show
alongside the Red light that the device has registered
an above threshold impact. The wearer should seek
further medical attention and be checked for any
concussive symptoms at this point.
1
2
3
4
5
6
7
8
9
EN: To reset device after red light or to turn off device
simply press for 1 second to turn off the light, and
hold the button for 3 seconds and release to turn off
device. Your device is now in off state. To turn back on
to continue playing simply follow from step 5.
+
-
Battery
1 second