User's Guide

ManualsBrandsHCS ManualsElectronicsRemote Control

User guide for Remote Control RC4663801/01BR

The remote control has been programmed to control your set-top box and

also can be programmed to control the TV.

Installing Batteries

The remote requires 2xAAA batteries. A diagram inside the battery

compartment of the remote indicates proper placement of the batteries.

When batteries are properly installed, the remote can start work.

Know your Remote

The diagram below describes each key on your remote control. Functions

may vary between different services. Refer to the user guide for your set-

top box for descriptions of specific functions.

Summary of content (7 pages)

PAGE 1
User guide for Remote Control RC4663801/01BR The remote control has been programmed to control your set-top box and also can be programmed to control the TV. Installing Batteries The remote requires 2xAAA batteries. A diagram inside the battery compartment of the remote indicates proper placement of the batteries. When batteries are properly installed, the remote can start work. Know your Remote The diagram below describes each key on your remote control. Functions may vary between different services.
PAGE 2
STB IR key code table
PAGE 3
STB RF key code table
PAGE 4
Product Introduction Set STB Control Medium 1) Set STB control medium to IR Press <<5+OK>> simultaneously for 3 seconds. 2) Set STB control medium to RF Press << 6+OK>> simultaneously for 3 seconds. 3) Start Pairing Press <<2+OK>> simultaneously for 3 seconds. 4) Factory Reset Press << 7+9>> simultaneously for 3 seconds. Voice Function RCU features a button to activate the voice search application to search for content by speaking through the remote’s built-in microphone.
PAGE 5
From diagram above, the STB can transfer the RCU firmware by the BLE link. The OTA process can be triggered by the user using the RCU or by the STB itself. The RCU OTA IMAGE need to be downloaded into the STB itself. After the OTA is completed, the RCU will have a new firmware. Simple Setup 1) Simple Setup is a feature helps user to automatically set up the remote control via STB. After being set by Simple Setup, the RCU will be able to control TV/AMP.
PAGE 6
1) All LEDs are off. 2) IR and RF communications are stopped. 3) Any key press will wake up the RC. FCC Notice: FCC ID: 2AGOFRC466A This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
PAGE 7
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. IC Notice： RSS-GEN This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.