User's Guide

ManualsBrandsHCS ManualsElectronicsRemote Control

User guide for Remote Control RC4262001/01R

The remote control has been programmed to control your set-top box and can be programmed

to control your TV.

Installing Batteries

The remote requires 2xAAA batteries. A diagram inside the battery compartment of the remote

indicates proper placement of the batteries. When batteries are properly installed, the light on

the remote blinks each time a key is pressed

Know your Remote

The diagram below describes each key on your remote control. Functions may vary between

different services. Refer to the user guide for your set-top box for descriptions of specific

functions.

Summary of content (5 pages)

PAGE 1
User guide for Remote Control RC4262001/01R The remote control has been programmed to control your set-top box and can be programmed to control your TV. Installing Batteries The remote requires 2xAAA batteries. A diagram inside the battery compartment of the remote indicates proper placement of the batteries. When batteries are properly installed, the light on the remote blinks each time a key is pressed Know your Remote The diagram below describes each key on your remote control.
PAGE 2
STB IR key code table
PAGE 3
STB RF key code table
PAGE 4
Product Introduction 1) This RCU is transmitting IR and RF. There is a simple set up feature for TV/Home Theatre device. 2) The RCU can be set-up to control a RF or an IR STB (mutually exclusive). 3) The RF platform is BLE, using HOGP as the top layer. Before the RCU can control the STB, the RCU must pair with the STB first. 4) The IR protocol to control the STB is NEC. When RCU is not connected to any STB via BLE, MCU use IR to control STB.
PAGE 5
Simple Setup 1) Simple Setup is a feature helps user to automatically set up the remote control via STB. After being set by Simple Setup, the RCU will be able to control TV/AMP. 2) Below IR function could be configured to control TV through simple setup: TV Power, TV Mute, TV Vol+ and TV vol-. 3) After a successful simple setup for TV, RCU will automatically set dual-function keys into TV mode Battery Voltage Monitor LVD check will be triggered after a signal key is released in user mode. 1.