User's Manual

Insert the 4 AA alkaline batteries (included) in the Pronto.
The red LED on the Pronto will start blinking.
Inserta las 4 pilas alcalinas AA (incluidas) en tu Pronto.
El LED rojo en el Pronto empezará a parpadear.
Insérez les 4 piles alcalines AA (inclus) dans votre Pronto.
La LED rouge sur le Pronto se met à clignoter.
Quick Start Guide/ Prise en Main /
Para Empezar
www.getpronto.com
This device complies with part 15 of the FCC Rules. Operation is subject to the following two condi-
tions: (1) This device may not cause harmful interference, and (2) this device must accept any inter-
ference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital de-
vice, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protec-
tion against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmfu
l
interference to radio or television reception, which can be determined by turning the equipment
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
connected.
- Consult the dealer or an experienced radio/TV technician for help.
-
ance to this equipment would void the user’s authority to operate this device.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d‘Industrie Canada applicables aux appareils radio ex-
em
pts de licence. L‘exploitation est autorisée aux deux conditions suivantes : (1) l‘appareil ne doit
pas produire de brouillage, et (2) l‘appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d‘en compromettre le fonctionnement.
3139
226 2788.2