Installation Guide
INSTALLATION INSTRUCTIONS
Please read carefully and save these instructions.
Don’t discard any of the packaging until you are sure that you have all of the parts and the fittings.
Make sure the main power must be cut off before installation.
IMPORTANT
This product contains glass parts. Care must be taken when fitting or handling these parts to prevent
personal injury or damage to the products; if the glass is broken, please stop using it and replace it from agent
or manufacturer.
Ensure the mounting surface is dry and strong enough to bear four times the weight of fixture for the
safe fitting of this fixture;
Care must be taken before drilling fixing holes to avoid any existing wiring or pipe work that may be
concealed.
INSTALLATION
Please refer the installation diagram on the back of the page.
1)
1)
2)
3)
Connect the cable by the screw-on wire connectors supplied in accordance with following codes: Black wire to Live
Terminal ( L ), White wire to Neutral Terminal ( N ), Green wire to Earth Terminal ( E ) (120V, 60Hz). Then mounting the
Cabinet on the wall and the install the anti-pulling bracket at below with screws(See page 6)
1)
Use pencil to dimensions of the cabinet body to recessed on the wall, connect the wires in accordance by the wire
connections instructions above, then use the screws to install the cabinet body into the wall by the screw positions
inside.(See page 8)
Apply to the below style of LED Medicine Cabinet
1 / 8
Installa the aluminum panel on two side by the screw holes inside the cabinet( See Pic. 7 )
Open the carton package, take out the EPE on the mirror front, then put it on the floor. Take out the whole mirror
from the PE bag and lay down
on the polyfoam on the floor, mirror face down. Then remove the mirror door to
prepare the next installation, prepare the installation tools and the fittings bag, see the parts list(See page 3&4)
Measure the distances to prepare the space for the LED Medicine cabinet on the wall, then use pencil to mark down
the screws postions, drill holes and install the aluminum hanger on the wall.(See page 5)
Wall mounting installations
Recessed
Install the glass shelf by the plastic holder provided at the fittings bag. adjust the hinges if needed(See page 9)
Installations of glass shelves and mirror door adjustable
Functions
Touch sensor switch - for control the lights on/off OR long press for dimmable
Defogger - Clear the mirror from bathroom steam
Touch sensor switch - to change the color temperature by short or long press