INSTALLATION MANUAL
IMPORTANT SAFETY INSTRUCTIONS When using an electrical furnishing, basic precautions should always be followed ,including the following: WARNING: To reduce the risk of burns,fire,electric shock or injury to persons. Use this furnishing only for its intended use as described in these instructions. Do not use attachments not recommended by the manufacturer. Never drop or insert any object into any opening.Do not use outdoors. WARNING: Risk of electric shock.
HARDWARE AND TOOLS 1/4”& 1/8” Drill Bits Pencil Level Power Drill Mallet Tape Measure HARDWARE LISTS ITEM IMAGE NAME Screw ST4*35 Wall Anchor Aluminum Alloy Plate Level and mark the mirror's location on the wall.
Use the tape measure the height, and draw the horizontal, line and the vertical line of the wash-basin. Measure the distance of the mirror hole, and mark the hole place on the wall. Drill and insert the Wall Anchor, Drive in the screw cross the bottom support.
Align the Alloy Plate of the mirror with the ones on wall and hang them to complete the installation.
Introduction of Touch Function After power on, the button shows white and it is in waiting stagte, click to turn on the light function and the button turn on yellow. Click again to turn off the light function and the button to turn to white. Long click the button to make the light gradually dims Click the button again and the light gradually brightens After power on, the button shows white and it is in waiting state, click to turn on the defogging function and the button turn on yellow.
Ø D Ø - Mirror’s Width/Height D - Mirror’s Depth Unit: Inch SIZE Ø D 24 28 24 28 1.26 1.26 30 32 36 30 32 36 1.26 1.26 1.26 Note: All dimensions & specifications are approximate and subject to change without notice.