REPORT NO: 98E7540 FCC ID: NO9SNTUO4 DATE: JULY 15, 1998 EUT: INDUSTRIAL WIRELESS RADIO REMOTE CONTROL TRANSMITTER USER’S MANUAL PAGE COMPLIANCE CERTIFICATION SERVICES, INC. DOCUMENT NC:CCSUP4031B 1366 BORDEAUX DRIVE, SUNNYVALE, CA 94089 This report shall not be reproduced except in full, without the written approval of CCS.
Operating Instructions Radio Transmitter spectrum BESPECTACLED | Ward 97 1 FL Page | Owner’s Manual Installation , Operation and Maintenance HBC. radiometric , Foster City, CA 94404 , USA TR RATES 3.07.98 HBC. idiomatic reserves tho right (o tiler oc amend the above information without any caries.
Operating Instructions Radio Transmitter spectrum BESPECTACLED { Word 97 ] FL Page 2 Before proceeding with the installation, operation or maintenance of the radio control equipment it is important that the installation, operating, and maintenance personnel read this bulletin carefully in order to ensure the safe and efficient use of the hoist or crane.
Operating Instructions Radio Transmitter spectrum BESPECTACLED | Word 97 } FL Page 3 Table of Contents 1 Helpful HINES oovereressnscsssnsinssansssnnssos sme tans ass ras abscissas sas 4 2 Safety resilience 5 21 Warning NOELS weurciereeserssinenas ..5 2.2 Safety Notes Regarding Operation 6 2.3 Safety Notes when Operating the Transmitter 6 Safety Notes on the Charging Unit and the Battery... 7 24 Safety Notes Regarding Maintenance ...evacuee.
Operating Instructions Radio Transmitter spectrum BESPECTACLED { Ward 97 § FL Page 4 1 Helpful Hints Following symbols are used in the operating instructions at hand : Warnings This symbol will shew situations that could be dangerous for people or machines. Pay particular attention in reading the parts of this manual. Be careful and try to avoid these situations. Notes This symbol will show important operating hints to guarantee a tong working life to the apparatus. Do not forget to observe these notes.
Operating Instructions Radio Transmitter spectrum BESPECTACLED { Word 97 J §L Page 5 2 Safety Regulations & Strictly observe and always adhere to the respective regulations on labor safety and accident prevention when operating a radio controlled system ! Retrofitting of a radio control to a crane or machine is considered to be a major modification. The crane or machine must therefore be subject to an approval inspection.
Operating Instructions Radio Transmitter spectrum BESPECTACLED | Word 37 1 FL Page 6 2.2 Safety Notes Regarding Operation © © Before using the radio control system for the first time, read these operating instructions completely and carefully. In case of a defect, an emergency situation and whenever a malfunction occurs in the working area of the radio system.
Operating Instructions Radio Transmitter spectrum BESPECTACLED [ Word 97 1 FL Page 7 HSBC-radiomatic , Foster City, CA 94404, USA Safety Notes on the Charging Unit and the Battery © Operate the charging unit at about room temperature and protect it against overheating (e.g. direct sun radiation). Boost charging of Ni Cd batteries only in a temperature range between between 50 °F and 104 °F (10 °C and 40 °Cy. © Protect the battery contacts against accidental shortening! — Use the protective caps delivered.
Operating Instructions Radio Transmitter spectrum BESPECTACLED { Wend 97 J £1 Page 8 3 Description of the System HBC-radiomatic® , HBC-technos® or HBC-radiobus® are radio systems to control cranes and hoists. The system consists of a joystick transmitter with either two or three 2-step joysticks for three motions and a selector switch, one key switch and an EMERGENCY-STOP push-button, a battery charger with two rechargeable batteries and a receiver with an antenna.
Operating Instructions Radio Transmitter spectrum BESPECTACLED | Ward 97 | FL Page 10 Dimensions and Operating Elements of the spectrum Emergency-Stop push-bunion @ Compact joystick © Rotary switch @ Key switch “Transmitter ON" 3.3 Nameplate The nameplate indicates all important data of the radio equipment. Besides the service voltage, radio frequency and the address of the system, this plate also indicates the production number which is necessary in case of possible further inquiries or spare part orders.
Operating Instructions Radio Transmitter spectrum BESPECTACLED [ Word 87 ) FL Page 11 4 Operation 1. Before you start working, insert a charged battery into the battery compartment (item. The battery supplies the voltage required for the operation of the transmitter (6 V DC). Note : After inserting the battery, the nameplate must be visible. Operation of the transmitter will not be possible otherwise ! Unlock the EMERGENCY-STOP push-button (item @) by turning it.
Operating Instructions Radio Transmitter spectrum BESPECTACLED | Word 97 | FL. Transmitter Muting Function ( APO) Page 12 The transmitter features an auto muting function (APO = Auto Power Off) for current saving reasons. Whenever the transmitter APO function is activated, the radio transmitter will automatically be switched OFF about 15 minutes after the last move command has been input. PL OR Gti 10 1 Fig. left shows radio transmitter spectrum 2.
Operating Instructions Radio Transmitter spectrum BESPATTERS. DOC [ Wade #7 | FL Page 13 Slewing Gear Release ( on radio receivers FSE 735 / 740/760) Whenever the command "slewing gear release” is actuated by means of the remote control, it is important that the respective check be made. Due to the above, a clearly visible indicator lamp should be installed on the crane ~ possibly a flashing one. 4.
Operating Instructions Radio Transmitter spectrum BESPECTACLED | Word 97 | FL. Page 14 Infra key Infra key is an option that uses an infrared sensor to control the main contractor of the crane. The crane can only be started if the operator is in the field of the infrared sensor and not more than max, 66 feet (max. 20 meters) from the crane. Infrared sensor wih max. 18.4 ft (5 m} connecting cable fo the receiver Infrared transmitter activation Function of infra key (schematic view), 0.0.
Operating Instructions Radio Transmitter spectrum BESPECTACLED { Ward 97 } FL Page 15 Catch ~ Release (C/R) In the operating mode "catch — release” two Or more crane operators may use one radio transmitter each to operate one and the same crane. The possibility also exists to couple multiple transmitters with multiple receivers. The crane is equipped with a radio receiver which is capable of receiving and monitoring both radio frequencies.
Operating Instructions Radio Transmitter spectrum BESFECUS.DOC { Word 97 | FL Page 16 Tandem Operation Tandem option T1 allows two cranes to be operated in tandem (crane 1 or crane 2 or both) using only one transmitter. an tamer am, Tandem option T2 includes two complete radio control less for two cranes. Tandem operation is enabled using keys. If the key from transmitter 1 is inserted into transmitter 2, then transmitter 2 can control either crane, or both. Transmitter 1 is inactivate when its key is out.
Operating Instructions Radio Transmitter spectrum RESPECTFULNESS | Word $7 | FL. Page 17 4.2 Battery Chargers Fig. left shows battery charger, type FLG 105 that is suitable for one each of the battery types FuB 05 AA or FuB 3A (with dapper. Fig. right shows battery charger, type FLG 102 which is suitable for two each of the battery types FuB 10 AA, FuB 05 AA and FuB 3A (with adapter} or mixed.
Operating Instructions Radio Transmitter spectrum BESPECTACLED { Word 97 | FL. Page 18 5 Maintenance The radio system is largely maintenance-free. The following items should nevertheless be taken into account : © Make sure that the EMERGENCY-STOP push-button moves easily. Mortar residue and dirt may interfere with the operation of the switch or even render it impossible. © Inspect the rubber bellows of the compact joysticks regularly for leak tightness.
Operating Instructions Radio Transmitter spectrum BESPECTACLED | Word 97 | FL Bio me Page 19 6 Trouble-Shooting Note : Check the functions with the cabin or the cable control unit first ! Trouble Possible Cause Remedy No reaction whenever the transmitter is switched No operating voltage present. ~ Charge battery or insert a charged battery. — Check battery contacts for damage or contamination. ON. — Battery not charged or | Charge battery fully.