Operating Instructions
Operating Instructions
Radio Transmitter patrol
( Industrial Version )
BEPATRIUS-L.DOC [ Word 97 ] FL
Page 6 / 14
HBC-radiomatic, Inc. , Cincinnati , Ohio 45242 , USA
HBC-radiomatic reserves the right to alter or amend the above information without any notice. 2001-09-13
Radio Remote Control S
y
stem
2.2 Safety Notes Regarding Operation
➪
Warning to our Users :
In accordance to the rules and regulations of the FCC, any changes or
modifications made to our transmitter or receiver by you without the express
written consent of HBC-radiomatic, Inc. could void your authority to operate the
equipment under FCC’s rule 15.21 !
➪
Before using the radio control system for the first time, read these operating
instructions completely and carefully.
➪
In case of a defect, an emergency situation and whenever a malfunction occurs in
the working area of the radio system, it is required to de-energize the radio
equipment immediately until the cause of the fault has been located and repaired !
−
Switch OFF the transmitter via the EMERGENCY-STOP pushbutton.
−
Disconnect the connecting cable from the receiver.
➪
During breaks and at the end of work, disconnect the transmitter by means of the
key switch or the EMERGENCY-STOP pushbutton.
➪
Be cautious when working with the radio control. – When using the radio control,
choose a stable location from which you can see the entire working area.
➪
Usage of radio remote control systems outside of manufacturer’s guidelines
(section 3) may result in invalidity of the guarantee.
2.3 Safety Notes when Operating the Transmitter
➪
Before you start working, always verify the operation of the EMERGENCY-STOP
pushbutton.
➪
It is not allowed to leave a connected transmitter and not supervise it.
➪
In case of an emergency and in case of all sorts of problems in the working range
of the machinery or in case of a technical failure of the radio control, you must
stop the crane or machine by pressing the EMERGENCY-STOP pushbutton !
➪
During breaks and at the end of work, disconnect the transmitter by means of the
"ON / OFF" toggle switch.
➪
The operation of the transmitter is permissible only with the carrying set included
with the transmitter (possibility of mixing up the controls) !