Operating Instructions

Operating Instructions
Radio Transmitter eco L
BEECOLUS-L.DOC [ Word 97 ] FL
Page 6 / 18
2001-09-13HBC-radiomatic reserves the right to alter or amend the above information without any notice.
Radio Remote Control S
y
stem
HBC-radiomatic, Inc. , Cincinnati , Ohio 45242 , USA
2.2 Safety Notes Regarding Operation
Warning to our Users :
In accordance to the rules and regulations of the FCC, any changes or
modifications made to our transmitter or receiver by you without the express
written consent of HBC-radiomatic, Inc. could void your authority to operate the
equipment under FCC’s rule 15.21 !
Before using the radio control system for the first time, read these operating
instructions completely and carefully.
In case of a defect, an emergency situation and whenever a malfunction occurs in
the working area of the radio system, it is required to de-energize the radio
equipment immediately until the cause of the fault has been located and repaired !
Switch OFF the transmitter via the EMERGENCY-STOP pushbutton.
Disconnect the connecting cable from the receiver.
During breaks and at the end of work, disconnect the transmitter by means of the
key switch or the EMERGENCY-STOP pushbutton.
Be cautious when working with the radio control. – When using the radio control,
choose a stable location from which you can see the entire working area.
Usage of radio remote control systems outside of manufacturer’s guidelines
(section 3) may result in invalidity of the guarantee.
2.3 Safety Notes when Operating the Transmitter
Before you start working, always verify the operation of the EMERGENCY-STOP
pushbutton.
It is not allowed to leave a connected transmitter and not supervise it.
In case of an emergency and in case of all sorts of problems in the working range
of the machinery or in case of a technical failure of the radio control, you must
stop the crane or machine by pressing the EMERGENCY-STOP pushbutton !
During breaks, disconnect the transmitter by means of the key switch or the
EMERGENCY-STOP pushbutton.
At the end of work, switch OFF the transmitter by means of the key switch, pull
out the key and store it at a safe place.
The operation of the transmitter is permissible only with the carrying set included
with the transmitter (possibility of mixing up the controls) !

Summary of content (2 pages)