® Aqua Logic Spa-side Remote Installation/Operation Manual for model AQL-SPASIDE-RF G LDLINE CONTROLS INC. North Kingstown, RI USA www.goldlinecontrols.
Compatibility This product is compatible with all Aqua Logic controls operating with software revision r1.10 or higher. To verify the software level of your Aqua Logic control, press the Menu button (possibly multiple times) until “Diagnostic Menu” is displayed. Next, press the “>” or “<“ keys (possibly mulitple times) until the main and display software revision levels are displayed (the “main” rev should be r1.10 or higher). If the software revision level is less than r1.
Operation The spa-side remote communicates with the base receiver on the Aqua Logic control unit using RF (radio frequency) technology. When you push a button on the spa-side remote, it sends a command and flashes the LED indicator once. After the spa-side remote receives a confirmation from the Aqua Logic base the receiver, the LED indicator on the spa-side remote flashes a 2nd time.
Heater ON/OFF Provided that the filter pump is running, normal Aqua Logic operation will turn the heater on until the desired temperature (see Settings Menu) is attained. The heater will then turn on periodically, as required, to maintain that temperature. When the ON button is pushed, the heater will turn on for a minimum of 5 minutes or until the water reaches 104°F This allows people in the spa to temporarily override the normal temperature setting.
Troubleshooting If you believe that your system is not operating properly or if you have a general question regarding system operation, you may call the Goldline Technical Service Dept. from Monday through Friday, 8AM to 8PM Eastern at 888-921-7665. 1. Can’t find the “Teach Wireless” display: Press the “menu” button (possibly more than once) until “Settings Menu” is displayed. Next, press the “<“ or “>” buttons (possibly more than once) unit the “Teach Wireless” display appears.
Aqua Rite®, Aqua Logic® & Aqua Trol® Limited Warranty This warranty statement is applicable to all Aqua Rite® Aqua Logic and Aqua Trol® units with product date codes of January 1, 2002 and after, and supersedes all warranty statements dated prior to January 1, 2002. This Limited Warranty applies only to Aqua Rite® Aqua Logic and Aqua Trol® Electronic Chlorine Generators. Refer to the appropriate limited warranty statement for all other Goldline Controls products.
4. 5. 6. ommended instructions contained in product’s owners manual. Problems resulting from failure to maintain pool water chemistry in accordance with recommended levels. Problems resulting from installing less than one Aqua Rite® or Aqua Logic unit per 40,000 gallons (25,000 gallons commercial/public pools) or one Aqua Trol unit per 18,000 gallons of pool water.
FCC Statement (Compliance Statement, Part 15.19): This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. WARNING (Part 15.21): Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.