Wireless Remote Display for Aqua Logic Automation and Chlorination (model AQL-REMOTE-RF-PS-8 shown above) Installation/Operation Manual for model AQL-REMOTE-RF-PS-4 AQL-REMOTE-RF-PS-8 AQL-REMOTE-RF-PS-16 G LDLINE CONTROLS INC. www.goldlinecontrols.
Compatibility This product is compatible with all Aqua Logic controls operating with software revision r2.00 or higher and Base Receivers with software revision r1.20 or higher. To verify the software level of your Aqua Logic control, press the Menu button (possibly multiple times) until “Diagnostic Menu” is displayed. Press the “>” or “<“ keys (possibly multiple times) until the main software revision level is displayed (the revision should be 2.00 or higher).
e. Reattach the wireless remote display/keypad to the baseplate. f. Plug the power supply into a 120VAC outlet. Wireless Remote Display unit Pull up on bottom edge to remove cover 4. Teach the unique Aqua Logic ID code: The base receiver attached to the Aqua Logic control unit has a unique ID code that ensures that your unit will not affect other systems in the neighborhood, and likewise, their remote will not affect your system. To teach the ID code to the wireless remote unit: Settings Menu a.
OPERATION The wireless remote display/keypad communicates with the base receiver on the Aqua Logic control unit using RF (radio frequency) technology. All of the display information is transmitted from the Aqua Logic control unit to the wireless remote display/keypad and all the button press information is transmitted by the Remote RF unit back to the Aqua Logic control unit.
output connector is plugged into the wireless remote display/keypad. If none of the displays are working, check that 120V power is being applied to the main control and that the 3A fuse (violet) is not blown. 5. Display backlight turns off after a period of time The display backlight should always illuminate when you press any key on the unit. If it turns off after a period of time, you can stop this by pressing the menu key (possibly multiple times) until “Settings Menu” appears.
10. Teach Wireless Fail. Please try again. This is usually caused by a button being held down for more than 3 seconds, falsely triggering the Teach Wireless mode. It can also be displayed if the Aqua Logic is not in the Teach Wireless mode. If the Aqua Logic is in Teach Wireless, then the radio signal may be too weak—try moving closer to the Aqua Logic main control unit base receiver. 11.
Goldline warrants Aqua Rite, Aqua Trol, and Aqua Logic products (products with Goldline part numbers starting with AQ-RITE-, AQ-TROL-, or AQ-LOGIC-) installed on commercial pools anywhere or any non-private single family residential pool or any pool outside of the USA or Canada to be free from defects in material or workmanship, under normal use and service for one year from date of the initial system installation, provided it is installed in accordance with the Goldline installation instructions and specif
FCC Statement (Compliance Statement, Part 15.19): This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. WARNING (Part 15.21): Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.