Aqua Logic Base Receiver Installation/Operation Manual for model AQL-BASE-RF G LDLINE CONTROLS INC. North Kingstown, RI USA www.goldlinecontrols.
Compatibility This product is compatible with all Aqua Logic controls operating software revision r1.10 or higher. To verify the software level of your Aqua Logic control: Press the Menu button (possibly multiple times) until “Diagnostic Menu” is displayed. Next, press the “>” or “<“ keys (possibly multiple times) until the main and display software revision levels are displayed (the “main” rev should be r1.10 or higher). If the software revision level is less than r1.
Installation Installation is very easy and should just take a few minutes. Disconnect power and then remove the panel from the Aqua Logic control unit. Remove the knock-out on the upper left side of the Aqua Logic main unit and mount the RF base station. Secure the base receiver in place by firmly tightening the nut from inside the Aqua Logic unit. Lastly, plug the pigtail cable into the “wireless connector” connector on the Aqua Logic main circuit board.
Operation Every Base Receiver is manufactured with a unique ID code. This allows private, secure communication with all of your remote devices while ignoring any signals transmitted by other wireless devices including any other Aqua Logic controls in the neighborhood. IMPORTANT: Before trying to use any remote device: You must "teach" the correct ID code to the remote device so it knows which base receiver to communicate with.
Troubleshooting If you believe that your system is not operating properly or if you have a general question regarding system operation, you may call the Goldline Technical Service Dept. from Monday through Friday, 8AM to 8PM Eastern at 888-921-7665. 1. Can’t find the “Teach Wireless” display: Press the “menu” button (possibly more than once) until “Settings Menu” is displayed. Next, press the “<“ or “>” buttons (possibly more than once) until “Teach Wireless” display appears.
Aqua Rite®, Aqua Logic® & Aqua Trol® Limited Warranty This warranty statement is applicable to all Aqua Rite® Aqua Logic and Aqua Trol® units with product date codes of January 1, 2002 and after, and supersedes all warranty statements dated prior to January 1, 2002. This Limited Warranty applies only to Aqua Rite® Aqua Logic and Aqua Trol® Electronic Chlorine Generators. Refer to the appropriate limited warranty statement for all other Goldline Controls products.
The express warranty above constitutes the entire warranty of Goldline Controls, Inc with respect to the Aqua Rite, Aqua Logic, and Aqua Trol products and IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING A WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL GOLDLINE CONTROLS, INC. BE RESPONSIBLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES OF ANY NATURE WHATSOEVER.
FCC Statement (Compliance Statement, Part 15.19): This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. WARNING (Part 15.21): Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.