User's Manual

AGES
3
+
TO INSERT BATTERIES (VEHICLE):
Phillips/cross head screwdriver (not included) needed to insert batteries. Loosen screw in battery
compartment cover (screw remains attached to cover). Remove cover. Insert 3 x 1.5V AA alkaline
batteries (not included) on top of fabric strap. Replace cover and tighten screw.
TO INSERT BATTERIES
(REMOTE CONTROL):
Phillips/cross head screwdriver (not included)
needed to insert batteries. Loosen screw in battery
compartment cover (screw remains attached to
cover). Remove cover. Insert 2 x 1.5V AA alkaline
batteries (not included). Replace cover and tighten
screw.
IMPORTANT: BATTERY INFORMATION
CAUTION:
1. TO AVOID BATTERY LEAKAGE
a. Always follow the instructions carefully. Use only batteries
specified and be sure to insert them correctly by matching the
+ and – polarity markings.
b. Do not mix old batteries and new batteries or standard
(carbon-zinc) with alkaline batteries.
c. Remove exhausted or dead batteries from the product.
d. Remove batteries if product is not to be played with for a
long time.
e. Do not short-circuit the supply terminals.
f. RECHARGEABLE BATTERIES: Do not mix these with any other
types of batteries. Always remove from the product before
recharging. Recharge batteries under adult supervision. DO NOT
RECHARGE OTHER TYPES OF BATTERIES.
2. Should this product cause, or be affected by, local electrical
interference, move it away from other electrical equipment. Reset
(switching off and back on again or removing and re-inserting
batteries) if necessary.
27 MHz
x2 1.5V AA
ALKALINE BATTERIES
REQUIRED
NOT INCLUDED
x3 1.5V AA
ALKALINE BATTERIES
REQUIRED
NOT INCLUDED
REMOTE CONTROL:
VEHICLE:
TM
R/C SPINNIN’
CHUCK