3 egress alk BATTERIES WAGGLED 1 J replace with 4x g ze alkalizing pore 185. 1 crisscross head scr r {not included TRANSVAAL size i hao to Centennial bate Mood Lamp features include sensors on the top of lis head that respond to your touch by Sighting up or playing melodies under your fingers. it has 4 light modes that you choose by tilting its head in a certain direction.
NOTE: to the “ON” position to activate your character's full range of features. Eyes/battery indicator/" talk” mode indicator « w “Talk” mode tag Neutral position Forward tit: ~~ Backward tilt This product is packaged in “TRY ME” mode.
Tilt head of Mood Lamp to select a light mode. You can either leave the lamp head tilted, or you can return it to the neutral position to stay in a particular mode. In any light mode, if you tile the head lef it will turn off the lights and put the limp back inch the default Musical Mood mode (see below for more information about Musical Mood). When a light mode listed below has beat detection [it senses your music and plays animations fo the beat), you will see this icon.
Tilt head forward fo get into this mode. When you touch the lamp head sensor (be sure fo hold your fingers in place for a few seconds), the lights will react by slowly glowing away from your touch and Mood Lamp will play a calm melody. Ah! For on automated groovy mood light show, hold your whole hand on the lamp head for several seconds. The light show will last about 30 minutes, then limp will go info sleep mode.
Tilt head backward fo get info this mode. Happy Mood has 6 different automated light shows, plus an caption that continuously loops through oll & shows. Tilt lamp head backward to choose your show; to get to the loop option, tilt head backward 7 times. Then sit back and enjoy the “dancing” lights! To conserve batteries, head sensors will shut off after 5 minutes if they aren't being touched. If it's in o light mode, the lamp will continue to glow for about 30 minutes, then it will go into sleep mode.
Who knew a Mood Lamp could have so much personality? Your ROOM TECH Mood Lamp shows its personality and moods with many different animated light patterns.
@® When your BEING characters “alk” to each other, you'll notice that they share mood and personality animations. They might even signal one another to make interesting sound effects. The more you interact with your BEING, the more they'll interact with each other! Once you've switched Mood Lamp on for the first time {which takes it out of “TRY ME” mode), the fabric tag becomes the “Talk” mode tag. If lets you choose whether your Mood Lamp can "ilk” to any other BEING characters you might have.
e DO NOT operate Mood Lamp near liquid or allow liquid to spill on Mood Lamp. © BE SURE 10 pick up and carry Mood Lamp by its base, not by its head. When tilling Mood Lamp’s head fo change modes, be sure to do it gently. = Mood Lamp may react fo other sounds or noises that it hears, other than music. Lamp freezes up or acts erratically Press the reset button using a a pen " fip or replace batteries.
@ When the batteries start to get low, your character's eyes will occasionally flash red to fet you know it needs fresh batteries. Use a Phillips/cross head screwdriver {not included) to loosen screw in battery compartment cover {screw remains AN CAUTION: 0 attached to cover]. Remove cover. Remove and discard old batteries. Replace with 4 x 1.5V “AA” size alkaline batteries. Replace cover and tighten screw. AVOID BATTERY LEAKAGE 1.
FCC STATEMENT This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference Thai may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCO Rules.