jbl On TOUR™ iBT Bluetooth® Portable Loudspeaker Owner’s Manual ®
Important Safety Instructions 1. Read these instructions. 11. Only use attachments/accessories specified by the manufacturer. 2. Keep these instructions. 4. Follow all instructions. 12. Use only with the cart, stand, tripod, bracket or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. 5. Do not use this apparatus near water. 13.
English fcc statement and WarninG FCC Information For Users This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference; and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Compact Design The JBL On Tour iBT portable loudspeaker is a complete two-channel audio system in one easy-to-place footprint. The JBL On Tour iBT loudspeaker delivers sound with a powerfully tuned digital audio path. Its clean and compact digital amplification, coupled with DSP (digital signal processing) equalization, efficiently provides the four JBL Odyssey® transducers with cool-running power.
English Volume Controls Battery Disposal Volume increase “+” Alkaline batteries are considered nonhazardous. Rechargeable batteries (i.e., nickel cadmium, nickel metal-hydride, lithium and lithiumion) are considered hazardous household materials and may pose an unnecessary health and safety risk. Volume decrease “–” Answer/end phone call (MFB) “ ” Microphone “ ” Battery Installation 1.
listeninG to a phone call from a Bluetooth-enabled device •T o mute a phone call: Press both Volume buttons on the JBL On Tour iBT system. To unmute the phone call: Press either Volume button on the JBL On Tour iBT unit. 1. M ake sure the JBL On Tour iBT speaker is paired (see Bluetooth Pairing section, on page 5). 2. W hen you hear your Bluetooth-enabled device’s ringtone from the JBL On Tour iBT system, press the MFB “ ” button to answer the phone call. Or 3.
English LISTENING TO MUSIC There are three ways to listen to music on your JBL On Tour iBT: • V ia Bluetooth technology from a Bluetooth-enabled device. •U sing the supplied Apple cable to connect an iPad, iPhone or iPod device to the JBL On Tour iBT’s USB port. •U sing a stereo 3.5mm audio cable (not supplied) to connect an audio device’s audio or headphone output to the JBL On Tour iBT’s auxiliary 3.5mm mini jack. 4. U se the Bluetooth-enabled device to control playback.
LISTENING TO MUSIC FROM A CONNECTED AUXILIARY DEVICE 1. Connect the auxiliary device to the JBL On Tour iBT system using a 3.5mm stereo audio cable (not supplied). 2. P ress the JBL On Tour iBT’s MFB “ ” button repeatedly until the Source LED lights Amber. This indicates that the Aux input source is selected. 3. C ontrol music playback through the auxiliary device. Adjust the volume using the “+” and “–” buttons located on the front of the JBL On Tour iBT unit.
English POWER AND SOURCE LEDs Specifications The Power and Source LED colors change to indicate the state of JBL On Tour iBT unit. Source LED Power LED LED State Indication Power LED Green, constant JBL On Tour iBT is on, powered by good batteries or its AC power supply. Green, flashing Source LED JBL On Tour iBT is in software upgrade mode. Amber, flashing Software upgrade failed. Amber, constant Batteries are low. White, constant Apple cable (USB) is the active source.
Troubleshooting Sound Quality Symptom Possible problem Solution Note There is no sound from your JBL On Tour iBT speaker. There is no power to the unit. Make sure the wall power outlet or power strip has power; make sure all switches for the outlet/power strip are on and that all switches for the speaker system are on. Is the Power LED glowing green? If the Power LED is not on, power is not getting to your JBL On Tour iBT system. Try the solutions shown. The source selection is incorrect.
English Troubleshooting Sound Quality (continued) Symptom Possible problem Solution There is distortion (static, crackling or hissing sounds). The noise may be caused by interference from a monitor, cell phone or other transmitting device. Turn the monitor or other device off to see if the noise is eliminated. Move the JBL On Tour iBT cables farther away from the monitor or other device. There is too much bass or treble. The JBL On Tour iBT system is being overdriven by an amplified audio source.
Troubleshooting charging Symptom Possible problem Solution Note Your iPod device or cell phone will not charge. The wrong adapter is being used. Make sure the correct adapter is being used for your specific iPod or cell phone model. Some cell phones cannot charge via USB without software from the charging system. Solution Note Troubleshooting pairing Symptom Possible problem The audio device does not pair with the JBL The audio device is not compatible with On Tour iBT system.
English HARMAN Consumer, Inc. 8500 Balboa Boulevard, Northridge, CA 91329 USA © 2011 HARMAN International Industries, Incorporated. All rights reserved. JBL and Odyssey are trademarks of HARMAN International Industries, Incorporated, registered in the United States and/or other countries. JBL On Tour is a trademark of HARMAN International Industries, Incorporated. The Bluetooth word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc.