HCG Odin Remote Control Specifications Deleted: December 29, 2010 February 16, 2011 Deleted: H Revision I
Document Release Record Date 2010.10.21 2010.10.22 Rev. A A+ Changes Concept of operation Clarify the Treble/Bass active and setting Authorization Ken. Li Ken.Li definition 2010.11.10 B Changed the definition of the buttons. Ken.Li Changed EQ control mode into 5 EQ scenes. Added LED Lights to indicate the audio sources. 2010.11.11 2010.11.11 C D Change the “switch eq setting” behavior Change the “Presses & holds Play/Pause” Vincent Leon behavior 2010.11.23 2010.11.26 2010.11.29 2010.12.
1 Layout and Buttons The Odin has following buttons on the remote control. Function Buttons 1 2 3 4 5 6 7 8 9 Enter/Ok (JBL Logo) Menu Scroll Up Scroll Down Left Right Volume Volume + Play/Pause 2 Button Functions We distinguish the function between a short and a long press of a key. Short press - takes up to 2 seconds, Long press - takes more than 2 seconds.
Button Event Short Press Enter/OK Systems response same function as iPod center “select” button, confirms selection Key SELECT If an alarm is activated then this stops the playing alarm. Long press switches EQ setting in loop and the indicating light shall Flash. The on and off Change_EQ rate should be 3 times. Menu Short Press same function as “menu” button on iPod. MENU Long Press Switch source among following : iPod / Bluetooth / Aux.
Remark : For the actual key code , please refer to another document “JBL Odin_Remote Control_key code_0.5.doc” 3 Remote Control LEDs White LED When any remote control button is pressed , the White LED will start blinking , once the button is released , then the white led will be off.
Page 4: [1] Deleted ViZhong Press Scroll Up and Scroll down simultaneously will toggle Video output on / off.
FCC WARNING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: Any changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.