User Manual

ManualsBrandsHarman Consumer ManualsElectronicsFreedom Bluetooth Dongle

jbl reference series 610

User Guide

English .........................2

Deutsch ........................ 9

Français .......................15

Español ...................... 21

Italiano ....................... 27

Dutch ......................... 33

Korean ........................39

Norwegian ................. 45

Danish ......................... 51

Japanese ..................... 57

Simpliﬁ ed Chinese .....63

Bluetooth

wireless headphones for iPod

JBLREF610DGLE

JBLREF610HDST

Summary of content (7 pages)

PAGE 1
User Guide English .........................2 Deutsch ........................9 Français .......................15 Español ...................... 21 Italiano ....................... 27 Dutch ......................... 33 Korean ........................ 39 Norwegian ................. 45 Danish .........................51 Japanese ..................... 57 Simpliﬁed Chinese .....
PAGE 2
fcc regulations Important Safety Instructions Please read the following precautions before use: FCC Declaration of Conformity Statement • • • • • • • • • • • • • • • Read these instructions, heed all warnings, and keep for future reference. Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings; a minimum distance of 10mm around the entire apparatus is required for sufficient ventilation.
PAGE 3
1. Package Contents 1. JBL Reference Series 610 Headphones 2. Carrying Case 3. Bluetooth Transceiver 4. Stereo Phono Adapter 5. Dual Airline Adapter 6. Battery Charger 7. 1.75-Meter Optional Audio Cable 7. 2. 3. 6. 4. 5. using your jbl reference series 610 wireless headphones Charging Your Headphones To optimize your JBL 610 headphone system’s performance, the unit must be fully charged prior to operation. 1.
PAGE 4
Starting Up Your Headphones and the Bluetooth Transceiver The JBL Reference Series 610 is designed for use with iPod generations 4G and above. For your hearing safety, please adjust your iPod volume to the minimum position prior to powering up your headphones. 1. Power “On” your headphones by pressing the power button located on the left ear cup. The blue LED on the headphone will light up (at ﬁrst solid, followed by three consecutive, quick ﬂashes – indicating that headphones are ready to be “discovered”).
PAGE 5
troubleshooting your jbl reference series 610 Symptom when used with Bluetooth transceiver Possible Problem Solution Note Headphone system is not powered “On”. Press down power button. Blue LED should go from solid to three consecutive, fast blinks, indicating that it’s ready to be “discovered” by transceiver or other audio source. Rechargeable headphone battery is low. Charge headphones by following the battery charging directions in this User Guide.
PAGE 6
Symptom when used with Bluetooth transceiver Possible Problem Solution Audio device does not support A2DP proﬁles. Audio device is not compatible. Verify with manufacturer. Headphone system is not powered “On”. Press down on power button. Headphone system is still paired to Bluetooth transceiver. Disconnect transceiver from iPod and turn headphone power “Off”, then back “On”. Note Symptom when used with Bluetooth transceiver Pairing Audio device does not pair with headphones.
PAGE 7
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.