Installation Sheet

Face Frame
(lip behind door)
Frameless
(no lip)
Cabinet & Drawer Requirements:
Side Clearance:
Measure the width of the opening and the width of the drawer
box. Opening – Drawer = 1-1/2” to 1-9/16”
7/32” to 1/2” of clearance between the width of the cabinet space
and the drawer per slide is required for installation.
! If the drawer box is not within these parameters, the drawer slide
will not function correctly.
Parts Included:
2 pcs Drawer slides
16 pcs Installation screws
Tools Required:
Pencil
Phillips Screwdriver
Drill with 1/8” drill bit
Level
Tape Measure
Cabinet and Drawer Measurements:
Ensure that the cabinet and drawer are both square by measuring
the distance from the front of each side to the back of the
opposite side of both the cabinet and drawer.
The maximum difference is 1/16”
! If the dierence is greater than 1/16” the slide will not work
correctly.
Frameless Cabinets
Install slide in cabinet
1. Separate the cabinet and drawer member of the slide by pressing
the non-handed tripper disconnect release then pulling the two
members apart.
! Take note of how the slides are oriented, which will be necessary
when reassembling the slide.
! The section with the Star shaped hole is the drawer member and
the section with the two sliding pieces is the cabinet member.
2. Measure from the top of the cabinet to the desired drawer
location. Draw a level line on the inside of the cabinet where the
top of the cabinet member will mount.
3. Use the line and a level to position the cabinet member to the side
of the cabinet ensuring that the front of the member is ush with
the front of the cabinet.
209FU Series
225 lb Extra Heavy Duty Full Extension Side Mount
Ball Bearing Slides with 1" Overtravel
Installation Instructions