Specifications Wall Bracket Dimensions 3.62″ L x 1″ W Battery Type One “AA” NiCd Solar Panel 2.12″ L x 0.75″ W (3 Solar Panels) Important Safety Information Installation Precautions 1. Install only according to these instructions. Improper installation can create hazards. 2. Wear ANSI-approved safety goggles and heavy-duty work gloves during installation. 3. Keep installation area clean and well lit. 4. Keep bystanders out of the area during installation. 5.
Installation Instructions Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document including all text under subheadings therein before set up or use of this product. Assembly of House Numbers 1. Remove the Screws (10) from the Back Board (8). 4. With the Number Board (6) out, select the numbers from the Number Labels (12). 2. Remove the small screw on the side/center of the Housing (1). 3.
Removing the Tab to Activate Battery There is a pull-off Tab (5) around the connection of the Battery (4) which blocks battery operation. This Tab disconnects the battery to protect it from draining during shipment. 1. Remove the Battery (4), and Tab (5). Save this Tab for future use. See Figure C. 3. Replace the Back Board (8) and secure with the Screws (10). Be careful not to stretch or strain wires. Make sure you have returned the side/ center screw into place. See Figure E.
Choosing a Location 1. An outdoor location with full, direct 3. If choosing a front gate as a location, sunlight is the best position for the Solar attach the Panel on a wall near the gate Address Panel. Shadowy locations will or on a Ground Stake that receives not allow the battery to charge fully and sunlight at least 6-8 hours a day. will reduce the hours of lighting at night. Check periodically to make sure panel does not come loose over time. 2.
Maintenance To remove dust, use a damp cloth. To remove grease or oil, use a detergent based cleaning solvent, rinse with damp cloth, and dry. Replacing the Battery 1. NiCd BATTERY MUST BE RECYCLED 5. Attach the Back Board (8) with the OR DISPOSED OF PROPERLY. Screws (10) and replace on your wall. Do not short, incinerate Screw (10) or open battery. 2. Remove the Solar Address Panel from the wall or ground stake. 3. Use a screwdriver to remove the Screws (10) on the Back Board (8). 4.
Parts List and Diagram Part 1 2 3 4 5 6 Description Housing Solar Panel Circuitry “AA” NiCd Battery Tab Number Board Qty. 1 3 1 1 1 1 Part 7 8 9 10 11 12 1 Description Reflector Box Back Board Wall Holder Screw Screw Number Label Set Qty. 1 1 1 10 2 1 2 3 4 5 6 12 7 8 11 9 10 Record Serial Number Here: Note: If product has no serial number, record month and year of purchase instead.
Limited 90 Day Warranty Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 90 days from the date of purchase.