User's Manual
Go Go Bird
User Manual
1 How to remove and charge lithium baery
a. Turn off the switch at the boom of Go Go Bird, pull out lithium
baery from the tail of Go Go Bird, refer to figure 1.
b. Plug lithium baery directly into USB charger, charger can be
connected to adaptor, computer etc., DC 5.0V power supply, refer
to figure 2.
c. The green signal light of the charger is on, indicang that power
is on; aer inserng lithium baery, red signal light is on, indicang
that the baery is charging; red signal light is off, indicang that
the lithium baery is full.
d. Aer charging finished, unplug the charger from DC 5.0V power
supply and extract the lithium baery promptly.
e. Plug the full lithium baery into the baery container, tail of Go
Go Bird, pay aenon to the inseron direcon, refer to figure 3.
2 How to insert and remove AAA baeries of
remote control
a. Turn off the switch of the remote control, extract the baery
cover,refer to figure 4.
b. Insert two 1.5V AAA baeries correctly based on polarity
idenficaon into baery compartment.
c. Reload baery cover, it is loaded correctly when you hear a slight
click. Remote control will automacally turn off in ten minutes
when not in use.
d. For AAA baeries that running out of power, please remove
from baery cover.
Lithium baery
Pull out
On/off
switch
Figure 1
Figure 2
USB Charger Lithium baery
Figure 3
Figure 5
Funcon buon
On/off switch
Signal light
Turn around
buon
3 How to pair Go Go Bird with remote control
Go Go bird already matched when leaving factory, if remote
control can connect with Go Go Bird, please ignore this step. If not,
please refer to below pairing steps.
a. Turn on the switch of Go Go Bird and place the remote control
close to Go Go Bird.
b. Press the funcon buon and turn around buon (B) of the
remote control at the same me (remote control should be off),
then press the switch buon of remote control, then the signal
light of remote control will be on,refer to figure 5.
c. Pay aenon to the signal light of Go Go Bird, if the signal light is
flashing, indicang that the pairing matching is successful.
If fail to match, please repeat above steps.
Figure 4
4 How to monitor remote control
a. Pull up the rocker (upwards), Go Go Bird will speed up; move
down the rocker (downwards), Go Go Bird will slow down, refer to
figure 6.
b. Move the rocker to the le (le), Go Go Bird will turn le; move
the rocker to the right (right), Go Go Bird will turn right.