User's Manual

Go Go Bird
User Manual
1 How to remove and charge lithium baery
a. Turn off the switch at the boom of Go Go Bird, pull out lithium
baery from the tail of Go Go Bird, refer to figure 1.
b. Plug lithium baery directly into USB charger, charger can be
connected to adaptor, computer etc., DC 5.0V power supply, refer
to figure 2.
c. The green signal light of the charger is on, indicang that power
is on; aer inserng lithium baery, red signal light is on, indicang
that the baery is charging; red signal light is off, indicang that
the lithium baery is full.
d. Aer charging finished, unplug the charger from DC 5.0V power
supply and extract the lithium baery promptly.
e. Plug the full lithium baery into the baery container, tail of Go
Go Bird, pay aenon to the inseron direcon, refer to figure 3.
2 How to insert and remove AAA baeries of
remote control
a. Turn off the switch of the remote control, extract the baery
cover,refer to figure 4.
b. Insert two 1.5V AAA baeries correctly based on polarity
idenficaon into baery compartment.
c. Reload baery cover, it is loaded correctly when you hear a slight
click. Remote control will automacally turn off in ten minutes
when not in use.
d. For AAA baeries that running out of power, please remove
from baery cover.
Lithium baery
Pull out
On/off
switch
Figure 1
Figure 2
USB Charger Lithium baery
Figure 3
Figure 5
Funcon buon
On/off switch
Signal light
Turn around
buon
3 How to pair Go Go Bird with remote control
Go Go bird already matched when leaving factory, if remote
control can connect with Go Go Bird, please ignore this step. If not,
please refer to below pairing steps.
a. Turn on the switch of Go Go Bird and place the remote control
close to Go Go Bird.
b. Press the funcon buon and turn around buon (B) of the
remote control at the same me (remote control should be off),
then press the switch buon of remote control, then the signal
light of remote control will be on,refer to figure 5.
c. Pay aenon to the signal light of Go Go Bird, if the signal light is
flashing, indicang that the pairing matching is successful.
If fail to match, please repeat above steps.
Figure 4
4 How to monitor remote control
a. Pull up the rocker (upwards), Go Go Bird will speed up; move
down the rocker (downwards), Go Go Bird will slow down, refer to
figure 6.
b. Move the rocker to the le (le), Go Go Bird will turn le; move
the rocker to the right (right), Go Go Bird will turn right.