User's Manual

ManualsBrandsHansong Technology ManualsElectronicsLS6-N22S-M (Network Media Module)

USER Manual

LS6-N22S-M

SPECIFICATIONS

1.power up for MT7620A with battery 7.4V

2.Connect to the PC with RS232.

3.run the CMD on PC

4.run the MT7620A's QA tools which given by the supplier.

5. The MT7620 router module with two antenna portswhich

pattern is MOMI,the two antenna are the same one.

The antenna manufacturer A:Suzhou point positive electronic

technology co.,ltd

Model No: RC8WFI0063A or Model No:FCIWF10779A

Ant. Gain: Ref Ant. spec

FCC Statement

This device complies with Part 15 of the FCC Rules / Industry

Canada licence-exempt RSS standard(s). Operation is subject to

the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference

received, including interference that may cause undesired

operation.

Le présent appareil est conforme aux CNR d'Industrie Canada

applicables aux appareils radio exempts de licence. L'exploitation

Summary of content (10 pages)

PAGE 1
USER Manual LS6-N22S-M SPECIFICATIONS 1.power up for MT7620A with battery 7.4V 2.Connect to the PC with RS232. 3.run the CMD on PC 4.run the MT7620A's QA tools which given by the supplier. 5. The MT7620 router module with two antenna ports which pattern is MOMI,the two antenna are the same one. The antenna manufacturer A:Suzhou point positive electronic technology co.,ltd Model No: RC8WFI0063A or Model No:FCIWF10779A Ant. Gain: Ref Ant.
PAGE 2
est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 3
help. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
PAGE 4
population ne puisse y être exposée à une distance de moin de 20 cm. Installer les antennes de facon à ce que le personnel ne puisse approcher à 20 cm ou moins de la position centrale de l’ antenne. La FCC des éltats-unis stipule que cet appareil doit être en tout temps éloigné d’au moins 20 cm des personnes pendant son functionnement. The devices must be installed and used in strict accordance with the manufacturer's instructions as described in the user documentation that comes with the product.
PAGE 5
LS6-N22S 1. Introduction Libre LS6-N22S is a complete network media module. It includes an 802.11n MAC and baseband, a 2.4 GHz 2x2 MIMI radio and FEM, a 580MHz MIPS® 24K™ CPU core, with supporting FLASH and DRAM memory. The module also includes all the necessary I/O and control interfaces required to build feature rich networked media products, yet cost effective with very little additional electronic design.
PAGE 6
LS6-N22S          Green AP Intelligent Clock Scaling (exclusive) DDR2: ODT off, Self-refresh mode I2C, I2S, SPI, UART, JTAG, GPIO I2S interface supports 16-bit/96kHz (slave mode) Hardware NAT with IPv6 WEP64/128, TKIP, AES, WPA, WPA2, WAPI QoS: WMM, WMM-PS WPS: PBC, PIN 3. LibreSync Features LibreSync modules have extensive software features for connected media streaming and control applications. These include system level control and interface features as well as networking features.
PAGE 7
LS6-N22S 4. Block Diagram Figure 4-1: LS6-N22S Block Diagram 5. Specifications 5.1. General Specification Parameter Model Product Name Chipset Standard Libre Wireless Technologies Description / Values LS6-N22S LibreSync LS6 Network Media Module MT7620A Wi-Fi – IEEE802.11b, IEEE802.11g, IEEE802.11n, standards Data Sheet: Network Media Module, Ver. 3.
PAGE 8
LS6-N22S Data Transfer Rate 1,2,5.5,6,11,12,18,22,24,30,36,48,54,60,90,120, and maximum of physical layer rate of 130Mbps Input Voltage 3.3 V ± 5 % Frequency Band Operating Temperature Dimensions 2.4 GHz -20˚C to + 55˚C 40mm X 26mm X 5.1mm (L x W x H) ± 0.2mm 5.2. Wi-Fi Specification Parameter Standard Data Rate Description / Values IEEE802.11b, IEEE802.11g, IEEE802.11n standards    Modulation    Network Architecture Operation Channel   2.
PAGE 9
LS6-N22S  Transmit Output Power    Receiver Sensitivity   Security 802.11b : < 19.5 dBm at 11Mbps 802.11g : < 16.5 dBm at 54Mbps 802.11n : < 15.5 dBm at MCS7 802.11b : -84 dBm at 11Mbps 802.11g : -73 dBm at 54 Mbps 802.11n : -64 dBm at 130 Mbps (MCS7) WEP 64&128 bit, WPA, WPA-PSK, WPA2, WPA2-PSK, WPS, IEEE 802.1x, IEEE 802.11i  Current Consumption  TX Mode : 420 mA RX Mode : 220 mA 6. Mechanical, Connectors and Interfaces 6.1. Physical Module Estimated at 40mm x 26mm x 5.
PAGE 10
LS6-N22S     Dimensions are in millimetres Dimensional tolerance is +/- 0.2mm PCB thickness is 1mm Design for 5.1mm physical Z height clearance (space for shields/clearance) Figure 6-2: LS6-N22S Top View With and Without Shield 6.2. Connector Specification Figure 6-3: LS6-N2SS Connector Specification Libre Wireless Technologies Data Sheet: Network Media Module, Ver. 3.