User's Manual

User Manual

The HS-DWAM80/D2DIA module is a wireless audio transceiver module. The module holds the

radio transceiver IC, the DARR80 digital audio baseband processor and associated components

and circuitry .

Basic Features:

--Low latency ( configurable from 10……18ms )

--In-room or multi-room usage (point to multi-point is also supported )

--Bi-directional data channel

--Automatic frequency allocation

--Automatically controlled transmitter / receiver antenna spatial diversity minimizes fading and

multipath effects.

Pairing function :

all units in the same wireless audio network are provided with a 16bit network ID,shielding the

network from neighbor audio networks.

The HS-DWAM80/D2DIA is used for both the transmitter and receiver .The module is configured

either through the I2C interface ,through the EEPROM or through the optional microcontroller.

if the FCC / IC identification

number is not visible when the module

is installed inside the host device, then

the outside of the device into which the module is installed must also display a label referring to the enclosed

This exterior label can use wording such as the following:

Any similar wording that expresses the same meaning may be used.

"Contains FCC ID:XCO-HSMD2DIA80 and IC:7756A- HSMD2DIA80."

module.

Label requirement:

PAGE 1
User Manual The HS-DWAM80/D2DIA module is a wireless audio transceiver module. The module holds the radio transceiver IC, the DARR80 digital audio baseband processor and associated components and circuitry .
PAGE 2
REMINDING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.