Instruction Manual

ManualsBrandsHANLEI ManualsElectronicsWireless Remote Controller

Guangzhou Meimotor Electronic Technology Co., Ltd

Website：http://www.meimotor.com

Instruction Manual

For MCR-30 DC Motor Speed Control

INTRODUCTION

MCR-30 DC Motor Speed Controller can achieve simple automatic functions. It can adapt

to a wide DC low voltage operating range and it’s suitable for SCM, PLC and other upper

control.

TECHNICAL PARAMETERS

 Input supply voltage:12V-30VDC

 The output power:12V:250W(max) ; 24V:350W(max);

 The maximum output current: 30A (contain 30A fuse).

PRODUCT STRUCTURE DIAGRAM

 Controller

① Power terminal

② Limit sensor terminal

③ Manual switch control interface

④ Potentiometer interface

⑤ Receiving antenna

 Remote Control Key Function

KEY

FUNCTION

KEY

FUNCTION

Positive

Reverse

Stop

Blank

Speed Up

Speed Down

Summary of content (4 pages)

PAGE 1
Guangzhou Meimotor Electronic Technology Co., Ltd Instruction Manual For MCR-30 DC Motor Speed Control INTRODUCTION MCR-30 DC Motor Speed Controller can achieve simple automatic functions. It can adapt to a wide DC low voltage operating range and it’s suitable for SCM, PLC and other upper control. TECHNICAL PARAMETERS    Input supply voltage:12V-30VDC The output power:12V:250W(max) ; 24V:350W(max); The maximum output current: 30A (contain 30A fuse).
PAGE 2
Guangzhou Meimotor Electronic Technology Co., Ltd OPERATING INSTRUCTION   Remote controller Use to remote control speed and direction of motor Battery size: 23A 12V. Power and motor wiring diagram  Limit sensor control Motor working, corresponding sensor or switch is closed, then motor stop. 1. Mechanical stroke switch wiring diagram 2. 12-30V NPN sensor wiring diagram (normally open type sensor)  Manual switch control Connect two manual switches.
PAGE 3
Guangzhou Meimotor Electronic Technology Co., Ltd  Potentiometer Control the speed of the motor. The value of the potentiometer is 10K or 100K. Adjust the initial speed of the system. When the system starts, the position of the potentiometer determines the initial speed. Press the remote controller to speed up and down the motor. When adjust the potentiometer over 15 degree angle, recovery potentiometer to control speed.
PAGE 4
Federal Communications Commission (FCC) Statement. This device complies with part 15 of the FCC Rules. Operation is subject to the following twoconditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.