User's Manual

Module User Manual

A low-cost and low-power consumption module which has all of the Wi-Fi functionalities. The highly

integrated module makes the possibilities of web browsing, VoIP, video stream applications.

With seamless roaming capabilities and advanced security, also could interact with different vendors’

802.11a/b/g/n 1x1 Access Points in the wireless LAN.

Wi-Fi Dual-band 1x1 802.11a/b/g/n,The wireless module complies with IEEE 802.11 a/b/g/n standard

and it can achieve up to a speed of 150Mbps when using 40MHz bandwidth. The integrated module

provides USB2.0 interface for Wi-Fi.

OEM/Integrators Installation Manual

Important Notice to OEM integrators

1. This module is limited to OEM installation ONLY.

2. This module is limited to installation in mobile or fixed applications, according to Part 2.1091(b).

3. The separate approval is required for all other operating configurations, including portable

configurations with respect to Part 2.1093 and different antenna configurations

4. For FCC Part 15.31 (h) and (k): The host manufacturer is responsible for additional testing to verify

compliance as a composite system. When testing the host device for compliance with Part 15 Subpart B,

the host manufacturer is required to show compliance with Part 15 Subpart B while the transmitter

module(s) are installed and operating. The modules should be transmitting and the evaluation should

confirm that the module's intentional emissions are compliant (i.e. fundamental and out of band

emissions). The host manufacturer must verify that there are no additional unintentional emissions

other than what is permitted in Part 15 Subpart B or emissions are complaint with the transmitter(s)

rule(s). The Grantee will provide guidance to the host manufacturer for Part 15 B requirements if

needed.

IMPORTANT NOTE:

In the event that these conditions can not be met (for example certain laptop configurations or

co-location with another transmitter), then the FCC authorization is no longer considered valid and the

FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be

responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC

authorization.

End Product Labeling

The final end product must be labeled in a visible area with the following:

“Contains Transmitter Module FCC ID:2AG7C-6131E-U or Contains FCC ID:2AG7C-6131E-U ”.

Manual Information to the End User

The OEM integrator has to be aware not to provide information to the end user regarding how to install

or remove this RF module in the user’s manual of the end product which integrates this module.

Federal Communication Commission Interference Statement This equipment has been tested and found

to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications.

PAGE 1
Module User Manual A low-cost and low-power consumption module which has all of the Wi-Fi functionalities. The highly integrated module makes the possibilities of web browsing, VoIP, video stream applications. With seamless roaming capabilities and advanced security, also could interact with different vendors’ 802.11a/b/g/n 1x1 Access Points in the wireless LAN. Wi-Fi Dual-band 1x1 802.11a/b/g/n,The wireless module complies with IEEE 802.
PAGE 2
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver.