About the Documents The documents include instructions for using and managing the product. Pictures, charts, images and all other information hereinafter are for description and explanation only. The information contained in the documents is subject to change, without notice, due to firmware updates or other reasons. Please find the latest version in the website (http://www.ezvizlife.com). Any and all information, including, among others, wordings, pictures, graphs are the properties of EZVIZ Inc.
EU Conformity Statement This product and - if applicable - the supplied accessories too are marked with "CE" and comply therefore with the applicable harmonized European standards listed under the Radio Equipment Directive 2014/53/EU, the EMC Directive 2014/30/EU, the RoHS Directive 2011/65/EU. 2012/19/EU (WEEE directive): Products marked with this symbol cannot be disposed of as unsorted municipal waste in the European Union.
Basic Information Box Contents Vault Plus (x1) Power Adapter (x1) Accessories (x1) Quick Start Guide (x1) For models equipped with HDDs, the accessories are not included in the box contents. For models not equipped with HDDs, the accessories include screw kits, and HDD radiator. Rear Panel Overview WAN Interface For Router Power Input 12V 1.5A RESET Hole Insert a pin and hold for 10s The device restores and reboots LAN Interface for Cameras The cables with dotted lines above are not included.
Product View LED Indicator Status One-Touch Access Press the button and the system status indicator flashes. The Ezviz cameras nearby automatically connect to the Wi-Fi within two minutes. Other devices may also be connected to the Wi-Fi by pushing WPS button within the same 2 minutes. (For Android devices, you can find the WPS function in Settings > WLAN > Advanced Settings.) Green: Device is starting up or working properly. System Status Indicator Blue: Network unconnected, upgrading or HDD formatting.
Wiring Cable Connection 1. Connect the WAN interface of Vault Plus to the LAN interface of router, see figure below. When the connection succeeds, the WAN network indicator displays green, and the system status indicator displays green. 2. (Optional) Connect the LAN interface of Vault Plus to the computer. 3. Connect the power cable to the Vault Plus, and the Vault Plus starts up within two minutes. If you want to install the HDD by yourself, refer to the Appendix.
Linkage Linking to Device 1. Download the App in your Phone (For users without an existing EZVIZ account) - Search for "EZVIZ" in the App Store/Google Play TM in your mobile device to download and install the App. - Launch the App. - Create an EZVIZ user account. 2. Add the Vault Plus and Camera - Log into the EZVIZ app. - Click the “+” on the upper-right hand corner to go to QR code scanning interface. - Scan the QR Code on Camera with the EZVIZ App (on device label).
Appendix HDD Installation 1. (Optional) Remove the rubber mats. 2. Loosen four screws on the bottom of the device to take apart the base, see figure below. 3. Stick the thermal conductive silicon pads to both sides of the HDD, and attach the HDD radiator to the silicone pads. 4. Use the four screws to secure the radiator to the HDD, see figure below. Thermal Conductive Silicon Pad HDD Radiator 5. Connect the data cable. Make sure the limit line (white) aligns with the connector edge. Limit Line 6.