NAUTIZ X9 MANUAL
COPYRIGHT Copyright © 2021 Handheld Group AB. All Rights Reserved. This document contains proprietary information protected by copyright. No part of this manual may be reproduced by any mechanical, electronic, or other means in any form without prior written permission of the manufacturer. DISCLAIMER The information in this document is subject to change without prior notice in order to improve the reliability, design and function. It does not represent a commitment on the part of the manufacturer.
DECLARATION OF CONFORMITY CE The CE symbol on your product indicates that it is in compliance with the directives of the Union European (EU). A Certificate of Compliance is available by contacting Technical Support. This product has passed the CE test for environmental specifications when shielded cables are used for external wiring. We recommend the use of shielded cables. FCC RF Exposure Information (SAR) This device meets the government’s requirements for exposure to radio waves.
RoHS Handheld Group AB certifies that all components in its products are in compliance and conform to the European Union’s Restriction of Use of Hazardous Substances in Electrical and Electronic Equipment (RoHS) Directive 2002/95/EC. The above mentioned directive was published on 2/13/2003. The main purpose of the directive is to prohibit the use of lead, mercury, cadmium, hexavalent chromium, polybrominated biphenyls (PBB), and polybrominated diphenyl ethers (PBDE) in electrical and electronic products.
Symbols Description This symbol of “CAUTION” indicates that there is a danger of injury to the user or a risk of damage to the product, should warning notices be disregarded. Important Safety Instructions Read these safety instructions carefully: 1. Read all cautions and warnings on the equipment. 2. Place this equipment on a reliable surface when installing. Dropping it or letting it fall may cause damage 3. Make sure the correct voltage is connected to the equipment. 4.
16. If one of the following situations arises, get the equipment checked by service personnel: a. The power cord or plug is damaged. b. Liquid has penetrated into the equipment. c. The equipment has been exposed to moisture. d. The equipment does not work well, or you cannot get it to work according to the user’s manual. e. The equipment has been dropped or damaged. f. The equipment has obvious signs of breakage. 17.
Rechargeable Battery Pack Safety With very little care, you can optimize the battery life and maximize the lifespan of the battery. Most importantly, use only the equipment in its ideal operating temperature – do not leave it in a hot trunk during the summer. Important Terms to Understand “Battery life” means the time the equipment will run before it must be recharged (sometimes this is also called “playtime” or “runtime”).
Disposing of the Equipment Within the European Union EU-wide legislation, as implemented in each Member State, requires that waste electrical and electronic products carrying the mark (left) must be disposed of separately from normal household waste. This includes monitors and electrical accessories, such as signal cables or power cords.
Warranty This product is warranted to be in good working order during the warranty period. Should this product fail to be in good working order at any time during this period, we will, at our option, replace or repair it at no additional charge except as set forth in the following terms. This warranty does not apply to products damaged by misuse, modifications, accident or disaster.
1.3 Parts of the Device NOTE Do not remove transparent film unless you are using the pistol grip accessory Ver 1.
1.4 Dimensions Ver 1.
1.5 Specifications System CPU Quad Core ARM Cortex-A53 2.0GHz OS Android 11 Memory 3GB Storage 32 GB eMMC Peripherals and Devices Front: 2.0 MP camera Camera Rear: 13.
GPS GPS/GLONASS NFC Yes I/O Interface USB Port 1 x micro USB 2.
2. GETTING STARTED 2.1 Installing microSD and SIM Card To install the microSD card and/or SIM card(s): 1. Pull the back cover release latch towards the bottom of the phone to unlock the latch. Latch locked Latch unlocked 2. Insert a small flathead screwdriver into the notch and gently pry up the cover. 3. Remove the battery, if inserted. The battery is secured by a red slider. Move the slider to the right so that you can remove the battery. Move the slider to the right to unlock the battery. Ver 1.
4. Insert the SIM cards / microSD card following the direction as shown in the graphic. • To insert SIM card(s): The device comes with two SIM card slots, each with their own supported networks. SIM card slot 1 supports 2G, 3G and 4G while slot 2 supports 2G network. Make sure to insert your SIM cards correctly. SIM slot 2: 2G SIM slot 1: 2G/3G/4G • To insert a microSD card: Push the microSD card cover toward SIM slot 1 to lift it up.
6. Replace the back cover and push the latch towards the cover to lock it. After the SIM card(s) are properly installed, the device is ready to use the cellular network. See 3.3 Using Cellular Network to know how to use them. 2.2 Charging the Battery You can charge the Nautiz X9 via the provided power adapter or computer USB connection. • Due to shipment, the battery is partially drained when the package is delivered to you.
Also, a battery indicator will appear in the Notification Area showing the charging percentage. The remaining charging time will also be displayed. When the battery is fully charged, unplug the USB cable from the device 2.3 Installing/Replacing the Battery In case you need to install or replace the battery, follow the steps below to access the battery chamber and replace the battery. 1. Pull the back cover release latch towards the bottom of the phone to unlock the latch. Latch locked Latch unlocked 2.
4. Insert the battery back to the compartment while ensuring gold contacts align with the device contacts. Then move the slider to the left to secure the battery. Move the slider to the left to secure the battery. 5. Replace the back cover and push the latch towards the cover to lock it. Ver 1.
2.4 Optimizing Battery Life To optimize the operating time of the battery, it is recommended that you do the following: Decrease the LCD display brightness. • Set a shorter timeout of inactivity to allow the screen enter sleep mode. • Turn off the display if you are not using it. • Always exit the applications if it is not in use. • Disable the Wi-Fi, Bluetooth or GPS function if you are not using it. • Disable the App that heavily drains the battery if you are not using it.
3.1.