User’s Manual (Model Name: HMVD-01GB, HMVD-512B)
< Introductions for Bluetooth & Hidden Area Testing> Preparation 1. Plug the device into the USB port of PC. 2. Check if the device has been successfully installed and connected. And run the StdDTool.exe. (Make sure that connection is properly working first then, run the StdDTool.exe) 3. Enter the drive letter of the installed removable disk(‘I’” as an example) into the blank at the bottom of the software as following, then click the ‘Removable Disk Select’ button.
BT TEST 1. Enter the preferred search time (’11 as an example) at the top of the software as following, then click the ‘Device Search’ button. (Before performing this stage, make sure that the BT headset is set to ‘paring ready’ mode) 2. If a device appear in the right pane, check the device vice which you want to pair, then click the ‘Device Paring’ Button. Then ‘Paring OK’ pop-up will appear as following picture. 3. Play any audio(music) file like MP3 to test if you can hear any sound. 4.
Hidden Area TEST 1. Perform the ‘Preparation’ stage as mentioned above. 2. Click the ‘File Select’ button on reselect the file to write in hidden area. 3. Select a Sector (‘0’ as an example. Sector=Address) 1 sector is 512 bytes. Basically starts from 1024 bytes.
4. Click the ‘Write Sector’ button, then ‘MCS_Write_Sectors Success’ pop-up will appear as following picture. 5.
if set the Sector Len to ‘2’, 1024(0x400) bytes will be read. if set the Sector Len to ‘4’, 2048 (0x800) bytes will be read. 6. Click the ‘Read Sector’ button.
Fe a t ure s Fully Qua lifie d Blue t oot h Syst e m Blue t oot h 2 .0 Spe c ific a t ion Com plia nt K a lim ba DSP Ope n Pla t form Co-Proc e ssor Full Spe e d Blue t oot h Ope ra t ion w it h Full Pic one t Support Ope ra t ing V olt a ge 2 .8 ~3 .6 V U ART I nt e rfa c e Wit h progra m m a ble ba ud ra t e up t o 1 .5 M ba ud w it h a n opt iona l bypa ss m ode Full Spe e d U SB v1 .
Cha ra c t e rist ic s Ele c t ric a l Cha ra c t e rist ic s Pow e r Consum pt ion Note : Conditions : 25°C, 3.
RF Cha ra c t e rist ic s
FCC Information This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules.