Use and Care Manual

11 in. High Velocity Air Circulator

Instruction Manual

MODEL NO.: TF-1010S

PLEASE READ, UNDERSTAND AND FOLLOW BEFORE

SAVE THESE INSTRUCTIONS.

READ AND SAVE THESE INSTRUCTIONS

FOR HOUSEHOLD USE ONLY

DIAGRAM

OPERATING INSTRUCTIONS

WARNING: Do not use this product in windows, as a risk of electrical shock

exists and serious personal injury and/or property damage may occur.

1. Set your fan on a level and dry surface.

2. Make sure the rotary switch is at “0” (OFF) position. Plug the unit into a 120Vac

60Hz outlet.

3. Adjust the fan head vertically to your desired angle.

4. To run on the unit, turn the rotary switch to “3” (HIGH), “2” (MEDIUM) or “1”

(LOW) position

5. To stop the unit, turn the rotary switch to “0” (OFF) position, then unplug the unit

from power outlet

6. Unplug the product from the electrical outlet when it is not in use or is left

unattended.

PAGE 1
DIAGRAM 11 in. High Velocity Air Circulator Instruction Manual MODEL NO.: TF-1010S OPERATING INSTRUCTIONS WARNING: Do not use this product in windows, as a risk of electrical shock exists and serious personal injury and/or property damage may occur. 1. Set your fan on a level and dry surface. 2. Make sure the rotary switch is at “0” (OFF) position. Plug the unit into a 120Vac 60Hz outlet. 3. Adjust the fan head vertically to your desired angle. 4.
PAGE 2
IMPORTANT SAFEGUARDS WARNING: To reduce the risk of electric shock and injury to persons, do not use in a window WARNING: To reduce the risk of fire or electrical hazard, DO NOT USE THIS FAN WITH ANY SOLID STATE SPEED CONTROL DEVICE. READ ALL INSTRUCTIONS BEFORE USING 1. WARNING: This appliance has a polarized plug (one blade is wider than the other).The polarized plug is not intended to be used in non-polarized outlets (having both slots the same size).
PAGE 3
CLEANING INSTRUCTIONS WARNING: To avoid the risk of electrical shock, always make sure the product is unplugged from the electrical outlet before cleaning or servicing. CAUTION: This fan is not intended to be disassembled for cleaning for internal parts (e.g. blade, motor). Disassembly may result in product damage. Never use liquids or abrasive cleaners to clean the product. 1. Wipe the exterior surfaces with a soft damp cloth. Dust can be removed from the Guard and Blades with a small vacuum. 2.