LRl Yy HAMPTON BAY.™ ™" USE AND CARE GUIDE TRANSFORMER ey HAMPTON BAY. Questions, problems, missing parts? Before resuming to the store, call Hampton Bay Customer Service p.m,, PST, Monday Friday, 9 a.m. 6 p.m., PST, Saturday WOLVERHAMPTON NORTHAMPTON THANK YOU Wa appropriates the trust and confidence you have paced in Hampton Bay through the purchase of this transformer. We strive to continually create «quality products designed to enhances your home.
Table of Contents Hardware Included Safety formation Package Consent . arrant astronomer What Is Covered . What Is Not Covered Troubleshooting Pr-installation .. Tools Required IMPORTANT SAFETY INFORMATION TO REDUCE RISK OF FIRE OR INJURY. ‘The secondary wiring is intended for shallow burial .( less than 6 inches / 152mm ) For use with low voltage outdoor landscape lighting system only. There are no serviceable parts Skein the power supply unit. DO NOT DISASSEMBLE. Do not submerge transformer.
WHAT IS COVERED The manufacturer warrants this transformer to be free from defaces in materials and workmanship for a period of two (2) years from date of purchase. This warranty applies only to the original consumer and only to products used in normal use and service.
Installation 1 Preparing the Cable Being careful when splitting NOT to expose tha copper wire, remove the landscape wire insulation 1/2 in. from both wires and twist ends. Also, refer to strip length glued on the transformer. 1/2in. (12.7 Separate/Split Connecting the Cable to the Transformer Lay the transformer on a fiat, stable surface and Insert the stripped end of one wire under the terminal clamping plate “COM”. Then tighten the screw. Repeat this procedure for clamping plate “12v”.
Installation (continued) Placing Your Fixtures and Routing the Cable Lay your fixtures (not Included) out where you want 1o locate them. Bs aura do not excess 30 watt rating of the transformer. Route the low voltage cable to the fixtures. If there is extra cable,coil after the last fixture. 4 Attaching Your Fixtures Turn the transformer on. Attach your fixtures to the cable to using cable connectors as shown. Place one connector on each side of the cable, then press together to lock.
Installation (continued) 5 Mounting the Transformer To mount directly to a wall surface use the included screws (AR) as shown, suitable for mounting within (0.3 the ground. When installing the screws, the spacing between the screw centers Is 3.15 In. (80 mm). See the template (D) for correct spacing. Hang the transformer (A) onto the screws (AA). A 12in.t0 48 in. (03mto12m) ! 3.15in.
Operation ON AT DUSK/OFF AT DAWN (Factory default setting) In this mods, the landscape lights will automatically tum on at dusk and tum off at dawn. Press ON AT DUSK /OFF AT DAWN button, the related indicator light will illuminate and “AU” (Auto) well display on screen. This mode Is now active. 2 ON AT DUSK /RUN TIME In this mode, the landscape lights will automatically turn on at dusk and off after the set time (hrs). Press ON AT DUSK /RUN TIME bunion, the related Indicator light will illuminate.
Troubleshooting Problem Probable Cause All of the lights fall to work » Check that the transformer power is on. Check If there Is a loose connection at the transformer screw terminal with the cable. » Check that the power switch is not in an OFF setting. Only some lights work » Check the connector to make sure the wire barbs have pierced the landscape cable. + Halogen or incandescent bulbs (if applicable) can be burned out. Use caution as the bulb can be hot.
HAMPTON BAY. Questions, problems, missing parts? Before returning to the store, call Hampton Bay Customer Service p.m,, PST, Monday Friday, 9 a.m. 6 p.m., PST, Saturday WOLVERHAMPTON NORTHAMPTON Retain this manual for future use.