Instructions / Assembly

ManualsBrandsHampton Bay ManualsOutdoor Heating48000 BTU Stainless Steel Patio Heater

ASSEMBLY INSTRUCTIONS

1. With the Base (I) upside down, attach

Wheel Assembly (J) using M8 x 15

mm Bolts (AA) and M8 Nuts (CC).

A J

3. Reverse the Base (I) and attach

Cylinder Housing assembly (G) using

M5 x 8 mm bolts (DD) though Shroud

Fix Brackets.

Note: The door on the cylinder

assembly (G) should be on the

opposite side of the wheel assembly

(J).

J I

x 2

M8 Nut

M8 x 15 mm Bolt

DD I

2. Reverse the Base (J), attach Shroud

Fix Brackets (H) using M5 x 8 mm

Bolts (DD).

Door

Summary of content (5 pages)

PAGE 1
ASSEMBLY INSTRUCTIONS 1. With the Base (I) upside down, attach Wheel Assembly (J) using M8 x 15 mm Bolts (AA) and M8 Nuts (CC). AA M 8 x 15 m m B olt x 2 CC M 8 N ut x 2 1 I 2. Reverse the Base (J), attach Shroud Fix Brackets (H) using M5 x 8 mm Bolts (DD). J CC AA 2 DD H I DD H 3. Reverse the Base (I) and attach Cylinder Housing assembly (G) using M5 x 8 mm bolts (DD) though Shroud Fix Brackets.
PAGE 2
ASSEMBLY INSTRUCTIONS 4 4. Attach Lower Pole assembly (F) to Cylinder Housing Assembly (G) using M6 x 10 mm bolts (EE),and then put Beauty Ring (E) through the Lower Pole assembly on top of Cylinder Housing Assembly (G). Back F E EE G EE M6 x 10 mm Bolt x4 5. Screw Reflector Spacers (BB) into the top of Burner Assembly (C). BB Reflector Spacer 5 x3 6. Feed the valve and gas hose and connect the Burner Assembly (C) to the Upper Pole (D). 6.1.
PAGE 3
ASSEMBLY INSTRUCTIONS 7. Feed the valve and gas hose and connect Upper Pole (D) to the Lower Pole Assembly (F). 7.1 Feed the valve and gas hose into and go through the Lower Pole Assembly 7.2 Screw Upper Pole (D) onto Lower Pole Assembly (F) until the holes on Upper Pole (D) is aligned to the holes on top of Lower Pole Assembly (F). Fix them by using three M5 x 8 mm Bolts (DD). Ensure they are fully tightened. 7 D F DD DD 8.
PAGE 4
ASSEMBLY INSTRUCTIONS 9. Attach dome assembly to Burner Assembly (C) by securing wing nuts (KK) to Reflector Spacers (BB). 9 KK KK Wing Nut x3 BB C 10. Connect Hose & Regulator Assembly (K) to 20lb.LP-gas cylinder (sold separately). Line up threads on fitting with those on regulator and rotate clockwise until tighten. HAND TIGHTEN ONLY. DO NOT USE ANY HAND TOOLS TO MAKE THIS CONNECTION. Be careful not to cross threads when screwing in fitting.
PAGE 5
ASSEMBLY INSTRUCTIONS 11. Attach strap inside of Cylinder Housing Assembly (G) to secure cylinder. Then, close door on Cylinder Housing Assembly (G) to complete installation. 11 SAFETY CHECK Checking for Leaks Your patio heater has been checked at all factory connections for leakage. To check the connection at the gas hose/regulator/cylinder: a. Make leakage solution by mixing 1 part liquid dish soap and 3 part water. b.