Instructions / Assembly

ManualsBrandsHampton Bay ManualsLandscape LightingCoffeeville Low Voltage Oil-Rubbed Bronze LED Path Light

PACKAGE CONTENTS

A – Lamp Body x1 C – Wire Connector x1 D – Ground Stake (6.693 in.) x1 E- Bulb x1

B – Socket x1 (with 12 in. wire attached to lamp body)

Assembly and Installation

Attaching and installing the light

Connecting the wires

WARNING: Never push the fixture into the ground by the lamp body (A)

or use a hammer to insert the ground stake (D) into the ground.

□ Insert the fixture wire on the wire connector (C) into the groove located on

the top of the ground stake (D).

□ Ensure the fixture wire on the wire connector (C) stays in the center of the

groove of the ground stake (D) to avoid damage to the fixture wire. Screw

the lamp body (A) onto the ground stake (D).

□ The LED bulb (E) is pre-installed in the socket (B). Remove the packaging

around the LED bulb (E).

□ Prepare a hole in the installation location. Use a tool such as a screwdriver

(sold separately) to prepare the installation hole to ensure the hole is not

larger than the ground stake (D).

□ Install the fixture in the ground by pushing on the foot step (1) on the

ground stake (D). Do not push on the lamp body (A).

NOTE: To change the LED bulb (E), pull the LED bulb (E) out of the

socket (B) by the base (2). The preinstalled LED bulb (E) is plastic.

WARNING: The wire connector (C) contacts have sharp edges for

piercing the main low voltage cable. To avoid injury, do not touch the

metal contacts.

CAUTION: The wire from low voltage power unit should be 12-16 AWG

type underground low Energy Circuit Cable.

IMPORTANT:

□ Protect the wiring by routing it in close proximity to the light

fitting, or next to a building structure such as a house or a deck.

□ The landscape wire and connector can also be hidden under

stone or buried under grass at a maximum depth of 6 in. (15.24

cm).

□ Do not install the fixture within 10 ft. of a pool, spa, or fountain.

□ Do not submerge the fixture in water.

□ Place the wire connector (C) on opposite sides of the low voltage

cable (not included) from the transformer (not included) where the

fixture will be located.

□ Align and fit the main low voltage cable vertically to the slot of the

wire connector (C).

□ Press the wire connector (C) together until it is locked around the

main low voltage cable. The pre-set prongs will pierce the cable

insulation and establish contact with the electrical wire inside.

□ Once the wire connector (C) is in place, it is recommended to wrap it

with electrical tape (not included).

□ After all fixtures are installed, turn on the transformer.

Summary of content (2 pages)

PAGE 1
PACKAGE CONTENTS A – Lamp Body x1 B – Socket x1 C – Wire Connector x1 (with 12 in. wire attached to lamp body) D – Ground Stake (6.693 in.) x1 E- Bulb x1 Assembly and Installation 2 1 Attaching and installing the light WARNING: The wire connector (C) contacts have sharp edges for piercing the main low voltage cable. To avoid injury, do not touch the metal contacts. WARNING: Never push the fixture into the ground by the lamp body (A) or use a hammer to insert the ground stake (D) into the ground.
PAGE 2
Care and Cleaning □ Clean the fixture with a soft dry cloth. □ Do not use any cleaners with chemicals, solvents or harsh abrasives. Troubleshooting Problem The fixture will not light. The light flickers (one fixture). The lights flicker (all fixtures). Possible Cause Solution □ □ There is a loose wire connector to the fixture. □ Check the outlet and ensure that a breaker or GFCI circuit has not been tripped.