Instructions / Assembly

1
Use and Care Guide
LED LOW VOLTAGE FLOOD LIGHT
PACKAGE CONTENTS
A – Lamp Body x4 B – Ground Stake (6.693 in.) x4 C – Wire Connector (with 12 in. wire attached to lamp body) x4
Assembly and Installation
1
A
ttaching and installing the light
2
Connecting the wires
WARNING: Never push the fixture into the ground by the lamp
body (A) or use a hammer to insert the ground stake (B) into the
ground.
□
Insert the fixture wire on the wire connector (C) into the groove located
on the top of the ground stake (B).
□
Screw the lamp body (A) onto the top of the ground stake (B). To avoid
damage to the fixture wire, ensure the fixture wire on the wire
connector (C) stays in the center of the groove on the stake as you
screw the lamp body (A) onto the top of the ground stake (B).
□
Prepare a hole in the installation location. Use a tool such as a
screwdriver to prepare the installation hole to ensure that the hole is
not larger than the ground stake (B).
□
Install the fixture in the ground by pushing on the foot step (1) on the
ground stake (B). Do not push on the lamp body (A).
□
The lamp body (A) can rotate up and down 145 degrees.
W
ARNING: The wire connector (C) contacts have sharp edges for
piercing the main low voltage cable. To avoid injury, do not touch
t
he metal contacts.
CAUTION: The wire from low voltage power unit should be 12-16
AWG type underground low Energy Circuit Cable.
IMPORTANT:
□
Protect the wiring by routing it in close proximity to the light
fitting, or next to a building structure such as a house or a
deck.
□
The landscape wire and connector can also be hidden under
stone or buried under grass at a maximum depth of 6 in.
(15.24 cm).
□
Do not install the fixture within 10 ft. of a pool, spa, or fountain.
□
Do not submerge the fixture in water.
□
Place the wire connector (C) on opposite sides of the low
voltage cable (not included) from the transformer (not included)
where the fixture will be located.
□
Align and fit the main low voltage cable vertically to the slot of
the wire connector (C).
□
Press the wire connector (C) together until it is locked around
the main low voltage cable. The pre-set prongs will pierce the
cable insulation and establish contact with the electrical wire
inside.
□
Once the wire connector (C) is in place, it is recommended to
wrap it with electrical tape (not included).
□
After all fixtures are installed, turn on the transformer.
Item #1002 272 171
M
odel #
IWH1501LS
-
2
-
4PK
B
C
A
A
C
B
C