Warranty

Item #XXXX XXX XXX
Model #HD41250
Use and Care Guide
SOLAR POST LIGHTS
PACKAGE CONTENTS
Assembly and Installation
1
Attaching and installing the light
2
Replacing the battery
Please read and save these instructions
q Using the 2X screws and 2X anchors supplied, install the unit (A).
Screws should be installed to match the 2 slots in the rear of the unit (A).
qRemove the solar cap.
qRemove the battery cover.
qRemove the old battery and replace with 1 new AA NiMh
rechargeable battery of same or greater mAh. USE
RECHARGEABLE BATTERIES ONLY.
qBe sure to insert the battery in proper direction.
qReplace the battery cover.
qReplace the solar cap.
A
B
C
A
A
Battery
Battery cover
A
NOTE: This operation should be done in the morning on a sunny day. This will allow
the light to receive a full 8 hours of sunlight so that the rechargeable battery can reach
maximum capacity.
Note : Clean the battery contacts and those of the device prior to battery installation.
Part Description Quantity
A
Solar Wall Light
2
B
Screws
4
C
Anchors
4
CC
Wood
Concrete
NOTE: If the solar panel is covered by a protective lm, remove it before using the
product. Remove the pull-tab from the battery door. Place the solar light in a location
where it can receive a full 8 hours of sunlight to allow the rechargeable battery/batteries
to reach maximum capacity.