Installation Guide

□ To mount the parts together, assemble the post (D), spike (E)
and xture head (A) together by screwing them together.
□ When inserting the spike into the ground make sure to hold the
bottom of the post to avoid breaking the xture.
□ Loosen the adjustment screw (C) by turning it
counterclockwise. Adjust the head to the desired angle. Re-
tighten the adjustment screw (C) when nished.
Item #1002 757 124
Model #HD33681
Use and Care Guide
LINE VOLTAGE LED FLOOD LIGHT
PACKAGE CONTENTS
Assembly and Installation
1
Attaching and installing the light
2
Adjusting the angle of the xture head
3
Plugging in the ood light
CAUTION: For outdoor use only.
CAUTION: Suitable for wet locations.
CAUTION: Risk of Fire - Space xture housing min. 6 in. from surrounding
structures.
CAUTION: DO NOT USE IN HAZARDOUS LOCATIONS AS REQUIRED BY THE
CANADIAN ELECTRICAL CODE PART 1.
CAUTION: RISK OF ELECTRIC SHOCK. Do not use with extension cord near
water or where water may accumulate. Keep lamp at least 16 feet from pools and
spas. Keep plugs and receptacles dry. For use only on GFCI protected circuits.
WARNING: Do not submerse.
WARNING: Install in accordance with all local codes and ordinances.
a) Use only three-wire outdoor extension cords that have three-prong grounding
plugs and grounding receptacles that accept the appliance’s plug.
b) Ground Fault Circuit Interrupter (GFCI) protection is to be provided on the
circuit(s) or outlet(s) to be used for the wet location portable luminaire. Receptacles
are available having built-in GFCI protection and are able to be used for this
measure of safety.
c) Use only with an extension cord for outdoor use, such as an extension cord of
cord type SEW, SEOW, SEOOW, SOW, SOOW, STW, STOW, STOOW, SJEW, SJEOW,
SJEOOW, SJW, SJOW, SJOOW, SJTW, SJTOW, or SJTOOW. OUTDOOR USE ONLY.
ETL LISTED UNDER MODEL # U000-1942
For light duty residential use and suitable for wet locations use.
Please read and save these instructions
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS
Lighted lamp is HOT!
A
B
C
E
D
F
Part Description Quantity
A
Head
1
B
Lens cover
1
C
Adjustment screws
2
D
Post
1
E
Spike
1
F
Power cord
1
NOTE: There are no serviceable parts inside the body and it is not recommended to
remove the lens cover assembly.
A
C
E
D
□ Plug in an outdoor ground fault circuit interruptor (GFCI).
WARNING: Do not operate the luminaire tting with a missing or damaged lens
or bulb protector.
WARNING: To reduce the risk of FIRE OR INJURY TO PERSONS:
WARNING: Before assembly of this kit read through the complete assembly
instructions step by step and note all cautions.
WARNING: Never push the xture into the ground by the lamp body (A) or use a
hammer to insert the spike (E) into the ground.