Warranty
Item #1001 090 125
Model #HDC28257WH75
Use and Care Guide
SOLAR STRING LIGHT
PACKAGE CONTENTS
Assembly and Installation
1
Attaching and installing the light
3
Battery replacement
2
Installation tips
Please read and save these instructions
Part Description Quantity
A
Solar panel
1
B
String light
1
C
Post
1
D
Spike
1
q If the solar panel is covered by a protective lm. Remove it before using
the product. Move the ON/OFF switch to the ON position. Place the solar
light in a location where it can receive a full 8 hours of sunlight to allow
the rechargeable battery/batteries to reach maximum capacity.
q If the soil is of a loose, sandy or organic type, grasp the post with both
hands near the spike and rmly push into the ground.
q If the soil is hard, pour some water onto the ground to soften it.
q If the soil is stony, soften the ground with a rake or shovel and remove
large rocks. Dig a small hole, insert the xture spike, replace the soil and
tap down.
q Never push the xture into the ground by the xture head.
q Attach the spike (D) to the post (C) by pressing them together and press
the post (C) into the bottom of the solar panel base (A).
qRemove the four screws from the back side of the solar panel (A).
qRemove the cover.
qRemove the old battery and replace with one new AA NiMh
rechargeable battery of same or greater mAh.
(USE RECHARGEABLE BATTERIES ONLY).
qBe sure to insert the battery in the proper direction.
qReplace the battery cover.
qReplace the four screws.
A
B
D
C
A
C
D
WARNING: When planting the spike ensure that there are no underground utility
lines or pipes.
NOTE: This operation should be done in the morning on a sunny day. This will allow
the light to receive a full 8 hours of sunlight so that the rechargeable battery can reach
maximum capacity.
NOTE : Clean the battery contacts and those of the device prior to battery installation.
A
Cover
Battery
Screws
ATTENTION
SPIKE
IS INSERTED
IN POST
ATTENTION
LE PIQUET
EST INSÉRÉ
DANS LE POTEAU