Warranty

ManualsBrandsHampton Bay ManualsOutdoor HeatingCrossridge 50,000BTU antique bronze finish gas fire pit

THANK YOU

continually create quality products designed to enhance your home. Visit us online to see our full line of products available for your home

improvement needs. Thank you for choosing Hampton Bay!

Cross Ridge Gas Fire Pit Table

1-855-HD-HAMPTON

HAMPTONBAY.COM

DANGER

· FLAMMABLE GAS UNDER PRESSURE.

LEAKING LP-GAS MAY CAUSE A FIRE OR EXPLOSION IF IGNITED

CAUSING SERIOUS BODILY INJURY OR DEATH.

CONTACT LP GAS SUPPLIER FOR REPAIRS, OR DISPOSAL OF THIS

CYLINDER OR UNUSED LP-GAS.

WARNING

FOR OUTDOOR USE ONlY.*

DO NOT USE OR STORE CYLINDER IN A BUILDING,

GARGE OR ENCLOSED AREA.

WARNING:

Know the odor of LP-gas. If you hear, see or smell

leaking LP-gas, immediately get everyone away

from the cylinder and call the Fire Department.

Do not attempt repairs.

Caution your LP-gas supplier to:

Be certain cylinder is purged of trapped air prior

LP-gas is heavier than air and may settle in low places

when dissipating.

Contact with the liquid contents of cylinder will cause

freeze burns to the skin.

Do not allow children to tamper or play with cylinder.

When not connected for use, keep cylinder valve turned

off. Self contained appliances shall be limited to a

cylinder of 30 lb capacity or less.

Do not use, store or transport cylinder where it would

be exposed to high temperatures. Relief valve may open

When transporting, keep cylinder secured in an upright

position which cylinder valve turned off.

DO NOT REMOVE, DEFACE, OR OBLITERATE THIS LABEL

*EXCEPT AS AUTHORIZED BY ANSI/NFPA 58.

DANGER. Do not store a spare LP cylinder under or near a barbecue grill, or other

serious injury may occour.

WHEN CONNECTING FOR USE:

Use only in compliance with applicable codes.

Read and follow manufacturer’s instructions.

Consult manufacturer’s instructions

concerning the cylinder connection provided

with your appliance.

Be sure regulator vent is not pointing up.

Turn off all valves on the appliance.

Do not check for gas leaks with a match or

Apply soapy water at areas marked

”X”. Open cylinder valve. If bubble appears,

close valve and have LP-gas service person

make needed repairs. Also, check appliance

valves and connections to make sure they

do not leak before lighting appliance.

Light appliance(s) following manufacturer’s

instructions.

When appliance is not in use, keep the

cylinder valve closed.

Cylinder

Pressure relief valve

Cylinder valve hand wheel

Point of connection

Liquid level indicator

(optional)

Item #1002 938 103

Model #G-FTB-51057B

USE AND CARE GUIDE

Questions, problems, missing parts? Before returning to the store,

call Hampton Bay Customer Service

8 a.m. - 7 p.m., EST, Monday – Friday, 9 a.m. – 6 p.m., EST, Saturday

Summary of content (17 pages)

PAGE 1
Item #1002 938 103 Model #G-FTB-51057B USE AND CARE GUIDE Cross Ridge Gas Fire Pit Table DANGER · FLAMMABLE GAS UNDER PRESSURE. LEAKING LP-GAS MAY CAUSE A FIRE OR EXPLOSION IF IGNITED CAUSING SERIOUS BODILY INJURY OR DEATH. CONTACT LP GAS SUPPLIER FOR REPAIRS, OR DISPOSAL OF THIS CYLINDER OR UNUSED LP-GAS. WARNING · FOR OUTDOOR USE ONlY.* DO NOT USE OR STORE CYLINDER IN A BUILDING, GARGE OR ENCLOSED AREA. WARNING: WHEN CONNECTING FOR USE: ·Know the odor of LP-gas.
PAGE 2
Table of Contents Table of Contents .......................................... ..........................2 Safety Information...............................................................2 Warranty............................................................................5 What is Covered..... .........................................................5 What is Not Covered.........................................................5 Pre-Assembly........……………………...…………………….5 Planning Assembly...................
PAGE 3
Safety Information (continued) You must provide propane gas and propane cylinder. Use a standard 20 lb. propane cylinder only. Use this heater only with a propane vapor withdrawal supply system. See Chapter 5 of the Standard for Storage and Handling of L The pressure regulator and hose assembly supplied with the appliance must be used. The installation must conform with local codes, or in absence of local codes, with National Fuel Gas Code, ANSI Z223.1.
PAGE 4
Safety Information (continued) Solid fuels shall not be burned in this appliance. The installation must conform with local codes or, in the absence of local codes, ANSIZ223. 1/NFPA54, NFPA58 Natural Gas and Propane Installation Code, CSA B149.1, or Propane Storage and Handling Code, B149.2.
PAGE 5
Warranty 1 YEAR LIMITED WARRANTY WHAT IS COVERED We warrant the metal frame to be free of manufacturing defects to the original purchaser for one year. WHAT IS NOT COVERED It remains the customer’s responsibility for freight and packaging charge to and from our service center. This warranty does not cover commercial use, hardware, acts of nature, fire, freezing and abusive use. In addition, purchased parts are not covered under this warranty.
PAGE 6
Pre-Assembly (continued) PACKAGE CONTENTS A B C D E E G F H I J K Part Description Quantity side panel 1 1 1 2 Part G H I J E leg E 2 K F side panel with window 1 A B C D lid lava rock (11 lbs) table top with burner 6 Description leg G door leg I gas tank support AAA battery Quantity 1 1 1 1 1
PAGE 7
Assembly 1 Assembling the legs E G I □ Attach the leg (G), the leg (I) and the leg (E) to the table top with burner (C) using four (4) M6 x10 mm bolts (AA). □ Do not tighten the bolts at this step. E C AA 2 Assembling the side panels D □ Attach each side panel (D) to the legs using four (4) M6 x 10 mm bolts (AA). □ Do not tighten the bolts at this step. AA 7 HAMPTONBAY.COM Please contact 1-855-HD-HAMPTON for further assistance.
PAGE 8
Assembly (continued) 3 Assembling the side panel with window F □ Attach the side panel with window (F) to the legs using four (4) M6 x10 mm bolts (AA). □ Do not tighten the bolts at this step. J AA 4 Assembling the gas tank support □ Attach the gas tank support (J) to the legs using four (4) M6 x 10 mm bolts (AA). □ Tighten all bolts (AA) with a Phillips screwdriver (not included).
PAGE 9
Assembly (continued) 5 Assembling the door H □ Orient the unit so that table top with burner is facing up. □ Slide the hinge of door (H) on to the leg (G). G 6 Place the lava rock B □ not placed on the ignition portion of the burner. Place the lid (A) over the top. □ The lid must be removed when the burner is in operation. The lid can be hung on the side panel. Wait until the unit cools before replacing the cover. Ignition A 9 HAMPTONBAY.
PAGE 10
Assembly (continued) 7 Assembling the cylinder □ Put the cylinder into the gas tank support (J), and secure the cyliner by tightening the screw in the gas tank support. Connect the hose and regulator to the cylinder. NOTE: The propane cylinder is sold separately. Use a standard 20 lb. propane cylinder only. Put the hose away from the bowl base during connect the propane cylinder. J 8 Installing the AAA battery □ Open the igniter and place the AAA battery (K) into the igniter. Then tighten clockwise.
PAGE 11
Operation WARNING: Never use this appliance for other than the intended use. DO NOT use this appliance to prepare food. Initial Lighting: of internal paints and lubricants used in the manufacturing process and does not occur again. Simply run the main burner on high for approximately one-half hour. WARNING: Children and adults should be alerted to the hazards of high surface temperatures and should stay away from the appliance to avoid burns or clothing ignition.
PAGE 12
Operation (continued) LEAK TESTING OPERATION WARNING: A leak test must be performed annually or if a part of the gas system is replaced. WARNING: Never use an open flame to check for gas leaks. Be certain no sparks or open flames are in the area while you check for leaks. Sparks or open flames will result in a fire or explosion, damage to property, serious bodily injury, or death. LEAK TESTING: This must be done before initial use, annually, and whenever any gas components are replaced or serviced.
PAGE 13
Operation (continued) LIGHTING INSTRUCTIONS 1. Press and hold electronic igniter button. WARNING 2. Turn the burner control to the high position, press and hold. When the burner lights, release the electronic igniter button. 3. Continue to depress the burner control knob for 30 seonds and then release. If the flame goes out, repeat the procedue. FOR YOUR SAFETY: Keep face and body away from burner area when lighting. Ensure burner controls are in the off position. Slowly turn on the gas supply valve. 4.
PAGE 14
Maintenance Storage between uses: □ □ □ □ Turn the control knob to “OFF” position. Disconnect LP source. Store heater upright in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail, snow, dust and debris). If desired, cover heater to protect exterior surfaces and to help prevent build up in air passages. NOTE: Wait until heater is cool before covering. Storage during periods of extended inactivity or when transporting: □ □ □ □ Turn the control knob to “OFF” position.
PAGE 15
Troubleshooting PROBLEM PROBLEM CAUSE SOLUTION The flame and heat are low when the valve is turned to high. The propane lighting procedure was not followed correctly. Ensure lighting procedure is followed carefully. The valve must be in the off position when the tank valve is turned on. Turn the tank on slowly to allow pressure to equalize. See Lighting Instructions in the Operating section. Burners burn with yellow flame, accompanied by the smell of gas.
PAGE 16
Service Parts A B C D E E G F H I J K AA Part A B C D E F Description Quantity side panel 1 1 1 2 leg E 2 side panel with window 1 lid lava rock (11 lbs) table top with burner Part G H I J K AA 16 Description leg G door leg I gas tank support AAA battery M6 x 10 mm Bolt Quantity 1 1 1 1 1 20
PAGE 17
Questions, problems, missing parts? Before returning to the store, call Hampton Bay Customer Service 8 a.m. – 7 p.m., EST, Monday – Friday, 9 a.m. – 6 p.m., EST, Saturday 1-855-HD-HAMPTON HAMPTONBAY.COM Retain this manual for future use.