Installation Guide

CHANDELIER

Instruction Manual

Please read carefully and save these instructions, as you may need them at a later date.

SAFETY

WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF; EITHER THE FUSE

IS REMOVED OR THE CIRCUIT BREAKER IS TURNED OFF. TURNING THE POWER OFF USING THE LIGHT SWITCH

IS NOT SUFFICIENT TO PREVENT ELECTRICAL SHOCK.

NOTE: The important safeguards and instructions appearing in this manual are not meant to cover all possible conditions or

situations that may occur. It must be understood that common sense, caution, and care, are factors which cannot be built

into any product. These factors must be supplied by the person(s) installing this unit.

READ & SAVE THESE INSTRUCTIONS

CAUTION: Before assembling the lighting fixture, refer to the section titled Wiring Connections. If you feel you do not have

enough electrical wiring experience, either refer to a do-it–yourself wiring handbook or have your lighting fixture installed by

a qualified, licensed electrician.

UNPACK THE PACKAGE

Check the contents to be sure everything is included

Tools Needed: Slotted screwdriver, Adjustable wrench, Step ladder, Wire cutters, wiring supplies as required by electrical

code.

INSTALLATION & OPERATION INSTRUCTIONS

GENERAL

Before starting the installation, disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at

the fuse box. Turning the power off using the light switch is not sufficient to prevent electrical shock.

All electrical connections must be in accordance with local and National Electrical Code (NEC) standards. If you are

unfamiliar with proper electrical wiring connections, obtain the services of a qualified electrician.

Remove the fixture and the mounting packages from the box and make sure that no parts are missing by referencing the

illustrations on the installation instructions.

Be sure to read these installation instructions and review the diagrams thoroughly before installation.

Assembly and Installation

1. Thread Iron Bar (20) into center column (21) until secure. Then adjust steel wire (19) length, Use Hex Wrench (18)

to thread Hex Screw (17) into Ball (16) tightly.

2. Thread Tube (24) onto threaded tube (22), then attach threaded tube (27) onto tube (24) and tighten until

secure. Place Cluster Assembly (25) through threaded tube (27) and then tighten with Hex Nut (26).

3. Place Cup (28) through threaded tube (27) and then tighten with Finial (29).

4. Make sure all the electrical is power off, and then attach the mounting plate (4) to the junction box (1) using the provided

machine screws (10).

PAGE 1
CHANDELIER Instruction Manual Please read carefully and save these instructions, as you may need them at a later date. SAFETY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF; EITHER THE FUSE IS REMOVED OR THE CIRCUIT BREAKER IS TURNED OFF. TURNING THE POWER OFF USING THE LIGHT SWITCH IS NOT SUFFICIENT TO PREVENT ELECTRICAL SHOCK. NOTE: The important safeguards and instructions appearing in this manual are not meant to cover all possible conditions or situations that may occur.
PAGE 2
5. Connect chain (14) with Canopy Loop (15) and hanging loop (12) together. Adjust the chain length as needed. Thread Fixture wire (6) and ground wire (3) through the chain (14), ring (13), hanging loop (12), canopy (11) and threaded tube (9). 6. Attach the ground wire (3) under the ground screw (5) marked “GND”, and fasten the ground screw (5) to the ground wire (3) until secure.