Instructions / Assembly

1
Use and Care Guide
LOW VOLTAGE OUTDOOR SPEAKER
PACKAGE CONTENTS
A – Speaker Body x1 B – Ground Stake (6.693 in.) x1 C – Wire Connector (with 36 in. wire D- Post x1 E – M sticker x1 F – S sticker x1
attached to speaker body) x1
A
ssembl
y
and Installation
1
Attaching and installing the speaker
2
Connecting the wires
NOTE: Be sure to read the entire guide before installing the
speaker.
WARNING: Never use a hammer to insert the ground stake (B)
into the ground.
Screw the post (D) onto the speaker body (A).
Insert the wire on the wire connector (C) into the groove located
on the top of the ground stake (B).
Screw the ground stake (B) onto the post (D). Ensure the wire on
the wire connector (C) stays in the center of the groove of the
ground stake (B) to avoid damage to the wire.
Prepare a hole in the installation location. Use a tool such as a
screwdriver (not included) to prepare the installation hole to
ensure that the hole is not larger than the ground stake (B).
Install the speaker in the ground by pushing on the foot step (1) on
the ground stake (B). Do not push on the speaker body (A).
CAUTION: The speaker is designed to connect to a low voltage cable
and a transformer, and NOT directly to AC line voltage.
WARNING: The wire connector (C) contacts have sharp edges for
piercing the main low voltage cable. To avoid injury, do not touch the
metal contacts.
CAUTION: The wire from the low voltage power unit should be 12-16
A
WG type underground Low Energy Circuit Cable.
IMPORTANT:
Protect the wiring by routing it in close proximity to the speaker
fitting, or next to a building structure such as a house or a deck.
The landscape wire and connector can also be hidden under stone
or buried under grass at a maximum depth of 6 in. (15.24 cm).
Do not install the speaker within 10 ft. of a pool, spa, or fountain,
or any location that may collect water.
Do not submerge the speaker in water.
Place the wire connector (C) on opposite sides of the low voltage
cable (not included) from the transformer (not included) where the
speaker will be located.
Align and fit the main low voltage cable vertically to the slot of the
wire connector (C).
Press the wire connector (C) together until it is locked around the
main low voltage cable. The pre-set prongs will pierce the cable
insulation and establish contact with the electrical wire inside.
Once the wire connector (C) is in place, it is recommended to wrap it
with electrical tape (not included).
Low voltage lights can also be connected on the same main low
voltage cable from the transformer.
After the speaker (and any low voltage lights) are installed, turn on
the transformer.
C
Item #1002 376 136
Model #B0029RA
B
A
D
M
E
S
F
A
D
C
D
B
1
C

Summary of content (11 pages)