Instructions / Assembly
1
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
PACKAGE CONTENTS
PLANNING FOR A SUCCESSFUL ASSEMBLY
Read all instructions before assembly and installation.
Inspect each part for defects that may have occurred during shipping.
Keep your receipt and these instructions for proof of purchase.
CHOOSING THE RIGHT LOCATION
Install your solar light in a location with full, direct sunlight. Do not install the
solar panel in shaded areas as these areas will not allow the batteries to fully
charge and reduce the nighttime operating hours for your light. Ensure that the
installation location is away from other nighttime light sources such as street or
porch lamps. These light sources may prevent your solar light from automatically
turning on.
Part Description Quantity
A Flag light head with post 1
B Solar panel with post 1
C Fixing bracket with connector 2
D Bracket 2
E Wall anchor 4
F Screw 4
G Bolt 4
H Wing nut 4
I 900mAh LiFePO4, 18500 rechargeable
battery (pre-installed)
1
HOW SOLAR WORKS
The solar light has a solar panel that converts sunlight into electricity. During the day, the converted electricity is stored in the rechargeable batteries.
At night, the solar light is powered by the batteries using the electricity stored during the day. The operating time depends on geographical location,
daily weather conditions, and season. For optimal performance during the evening, allow the batteries to charge for 6 to 7 hours in direct sunlight.
Assembly and Installation
Preparing for installation Installing the ag light on
a wall (Option 1)
□ Open the battery cover (1) of the solar panel
to remove the pull tab (II) (rst time use
only). This will allow the battery to make a
connection and become active.
□ Loosen, but do not remove, the connector (2)
on the xing bracket (C).
□ Put the connecting post of the ag light
(A) into the xing bracket (C) and twist the
connector (2) clockwise until it is tight.
□ Repeat the previous step to connect the
solar panel (B) to the xing bracket (C).
□ Drill a 1/2 in. hole into the mounting area for the
wall anchor (E).
□ Align the xing bracket (C) with wall anchor (E),
and use the screws (F) to mount the solar panel
(B).
□ Repeat the previous steps to mount the ag
light (A).
1 2
Installing the ag light on a
post (inline option)
□ Place the xing bracket (C) of the ag light
(A) and the xing bracket (C) of the solar
panel (B) against the post.
□ Install the bolts (G) through the xing
brackets (C) and fasten the wing nuts (H)
onto the bolts (G), twisting them clockwise
until tight.
2
B
C
D
F
E
G
A
H I
1
B
II
A
2
B
C
C
2
A
B
C
C
G
H
NOTE: For wood installation, use the screws
(F) only, the wall anchors are not necessary.
NOTE: Different mounting options allow for
various lighting angles. Choose the best
option for your application.
E
F
F
E
C
C
A
B
Solar LED Flag Light
Use and Care Guide
Item #1000 021 214
Model #79132