Instructions / Assembly

ManualsBrandsHampton Bay ManualsLighting15 in. Galvanized Finish Plastic LED Flicker Flame Outdoor Solar Lantern Lamp

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

PACKAGE CONTENTS

PLANNING FOR A SUCCESSFUL ASSEMBLY

□ Read all instructions before assembly and installation.

□ Inspect each part for defects that may have occurred during shipping.

□ Keep your receipt and these instructions for proof of purchase.

CHOOSING THE RIGHT LOCATION

Install your solar light in a location with full, direct sunlight. Do not install in shaded areas as these areas will not allow the batteries to fully charge and will reduce

the nighttime operating hours for your light. Ensure that the installation location is away from other nighttime light sources such as street or porch lamps. These light

sources may prevent your solar light from automatically turning on.

HOW SOLAR WORKS

The solar light has a solar panel that converts sunlight into electricity. During the day, the converted electricity is stored in the rechargeable batteries. At night, the

solar light is powered by the batteries using the electricity stored during the day. The operating time depends on geographical location, daily weather conditions, and

season. For optimal performance during the evening, allow the batteries to charge for 6 to 7 hours in direct sunlight.

Assembly and Installation

Preparing for installation

Item #xxxx xxx xxx,

xxxx xxx xxx

Model #93126,

93128

NOTE: Do not use a hammer. If the ground is hard, use

water to soften it or a trowel to loosen the soil.

Installing the solar light in the ground

□ Firmly slide the stake (F) into the bottom of the housing (E).

□ Push the assembly rmly into the ground.

Use and Care Guide

Solar Flicker Flame Lantern

A - Solar head

x 1

B - AA 1.2V

1000mAh Ni-Mh

rechargeable battery

(pre-installed) x 1

C - Battery cover

x 1

□ FOR FIRST TIME USE: Twist and remove the solar head (A) from the

housing (E). Slide the switch (aa) to the ON or FLAME position depending

on the desired function.

□ Replace the solar head (A) on the housing (E), twist to lock into place.

NOTE: The solar panel will turn the

light on automatically at dusk.

E - Housing

x 1

D - Flame bulb

(pre-installed)

x 1

F - Stake

x 2

BA D E

(underneath top cover)

□ The light assembly can also be used without the stake.

Just set it down on any at surface.

Option 2

Summary of content (2 pages)

PAGE 1
Item #xxxx xxx xxx, xxxx xxx xxx Model #93126, 93128 Use and Care Guide Solar Flicker Flame Lantern PACKAGE CONTENTS A B A - Solar head B - AA 1.2V 1000mAh Ni-Mh rechargeable battery (pre-installed) x 1 x1 C D C - Battery cover D - Flame bulb (pre-installed) x1 x1 F E E - Housing F - Stake x1 x2 PLANNING FOR A SUCCESSFUL ASSEMBLY □ Read all instructions before assembly and installation. □ Inspect each part for defects that may have occurred during shipping.
PAGE 2
Maintenance Replacing the battery C CAUTION: When replacing the battery, use one (1) 1000 mAh NiMH AA 1.2V rechargeable battery. IMPORTANT: Dispose of the batteries in accordance with local, state, and federal regulations. NOTE: For best performance, replace with a rechargable 1.2V AA NiMH battery of 1000 mAh or greater every 3 years or when performance diminishes. B □ Twist and remove the housing (E) from the solar head (A). □ Remove the battery cover (C).