Use and Care Manual
Table Of Contents
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
PACKAGE CONTENTS
Assembly and Installation
Attaching and installing the light
1
Item #1005 697 669
Model #62999
□ Detach and place the wire connector (D) on opposite sides of the low
voltage cable (not included) from the transformer (not included) where
the xture will be located.
□ Align and t the main low voltage cable vertically in the slot of the wire
connector as shown.
□ Press the wire connector (D) together until it is fully seated and locked
around the cable. Pre-set prongs will pierce the cable insulation and
establish contact. Turn on the power unit. If the light xture does not
turn on, repeat operations 2 and 3.
□ Once the clip-on connector is in place, we recommend wrapping it in
electrical tape (not included) for additional protection.
Connecting the wires
2
A - Fixture head
x 1
B - Connector with 12 in. wire
length (attached to xture)
x 1
CAUTION: The wire from the low voltage power unit shall
be 12-16 AWG type underground Low Energy Circuit
Cable.
IMPORTANT: Protect the wiring by routing it in close
proximity to the light or next to a building structure such as
a house or deck.
Do not bury the wiring by more than 6 in. (15.24 cm) in order
to connect to the main secondary wire.
Do not submerge xtures in water.
WARNING: The connector contacts (D) have sharp edges
for piercing the main low voltage cable. To avoid injury,
do not touch the metal contacts.
□ Choose a location to bury the xture head (A) into the ground.
A
B
NOTE: Do not use a hammer. If the ground is hard, use water
to soften it or a trowel to loosen the soil.
D
Use and Care Guide
LED Low Voltage Path Light
WARNING: Risk of electric shock do not install the light
within 10 ft. (3.05 m) of a pool, spa or fountain.