Installation Guide

INSTALLATION INSTRUCTIONS

For Trim Rings Models

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

Fig. 1

Fig. 2

Assembling the Trim Ring (Fig.1)

1. Place Glass Ring (C) into Trim Ring (D), then cover

with Baffle (A) and align the holes in Baffle with the holes

in Trim Ring.

2. Thread Screws (B) through the holes in baffle and tighten

it to Trim Ring.

INSTALLATION (Fig. 2)

3. Shut off the power at the circuit breaker.

4. Remove the light bulb from the recess can.

5. Adjust the Socket Plate (P) to the lowest position by

loosening the Wing-Nut (J) & tightening after proper

position is set.

6. Place the trim ring in position under the recess can.

7. Working from the inside of the can attach the Springs (N)

to the Slots (K) located on the Socket Plate (P) on both

side of the Bulb Holder (L).When attaching the spring

insert a pencil into the loop near the end of the spring.

Manipulate the hook into the Slot (K).

8. Repeat the same procedure for the other spring.

9. Place the Reflector (O) into the Trim Ring. Align Key

holes (G) with Pins (M) & turn to lock into position.

10. Replace the Light Bulb with Suction Cup Tool (I)

provide with trim ring.

(DO NOT EXCEED RECOMMENDED MAXIMUM

WATTAGE RATING!!!).

Your installation is now complete turn power back on.

CAUTION: Refer to the relamping label located near the

lamp holder for recommended maximum bulb wattage.

Note: Illustration (Fig.1& Fig.2) on this manual is for

installation purposes only. It may or may not be

identical to the fixture purchased.

In the event that you should have any installation

question or are missing parts, please contact Customer

Service. Customer service may be reached weekdays a

1-800-527-0998 between the hours of 8:00am and

5:00pm PST (Pacific Standard Time).

LA-965E/S

O G

PAGE 1
INSTALLATION INSTRUCTIONS For Trim Rings Models WARNING! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R . Fig. 1 Assembling the Trim Ring (Fig.1) 1. Place Glass Ring (C) into Trim Ring (D), then cover A with Baffle (A) and align the holes in Baffle with the holes B in Trim Ring. 2. Thread Screws (B) through the holes in baffle and tighten it to Trim Ring. C INSTALLATION (Fig. 2) D 3. Shut off the power at the circuit breaker. 4. Remove the light bulb from the recess can. 5.
PAGE 2
INSTRUCCIONES PARA LA INSTALACION Para modelos con anillos de ajuste ADVERTENCIA! CORTE LA CORRIENTE DESDE EL FUSIBLE O EL INTERRUPTOR CENTRAL. Montar el anillo de ajuste (Fig.1) Fig. 1 1. Coloque el anillo de cristal (C) en el anillo decorativo (D), luego cubra con la placa (A) y alinee los agujeros de la placa con los agujeros del anillo decorativo A 2. Pase los tornillos (B) por los agujeros de la placa y apriétela al anillo decorativo. B C INSTALACIÓN (Fig. 2) D 3.