User's Manual

ManualsBrandsHamg Shing ManualsAudio EquipmentBluetooth Headset

KBH010N-12 user’s guide

1． This device conforms to FCC Part 15.

This device complies with Part 15 of the FCC rules. Operation is

subject to the following two conditions: 1) this device may not cause

harmful interference, and 2) this device must accept any interference

received, including interference that may cause undesired operation.

z Pairing

Enter pairing mode: First, confirm that the headset is off. Then

press and hold the function button until the blue and red LEDs

flash alternatively.

Operate your phone to search the Bluetooth headset, when you

found the headset, enter pin code “0000” to complete the

progress.

After you complete the pairing progress, you can connected the

headset and conversation through the headset.

z Exit pairing mode

During pairing mode, short press the function button, and the

headset enter idle mode.

z Answer incoming call

Short press the function button to answer it when a call in.

z Reject incoming call

Press and hold the function button for 3 seconds to reject the

incoming call.

z End call

Short press the function button to end the conversation.

z Last number redial

Press and hold the function button for 3 seconds to redial the

last number in your phone redial call list.

Summary of content (3 pages)

PAGE 1
KBH010N-12 user’s guide 1． This device conforms to FCC Part 15. This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. z Pairing Enter pairing mode: First, confirm that the headset is off. Then press and hold the function button until the blue and red LEDs flash alternatively.
PAGE 2
z Voice dial Short press the function button to start voice dial function of your phone z Volume adjustment During conversation, you can short press the “+” or “-” button to adjust the conversation volume. z Microphone mute switch Press and hold the “+” and “-” buttons 3 seconds to switch between mute and unmute. z Power on/off Press and hold the function button for 3 seconds to turn off the headset during idle mode. Press and hold the function button for 3 seconds to turn on when the headset is off.
PAGE 3
Federal Communications Commission (FCC) Statement 15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. 15.105(b) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.