TSD2 USER INSTRUCTIONS 1. INTENDED USE OF TSD2 TSD2 is used for distance measurements and resulting data is sent wirelessly to a Wirepas protocol mesh network. The device has also an accelerometer. Typically TSD2 is used together with MTXH Thingsee Gateway in use cases where distance measurements are performed in several locations and this data is wirelessly collected and sent via 2G cellular connection to a data server / cloud. 2.
Snap the B cover in place (please note that the B cover can be placed only in one direction). The device starts making distance measurements about any objects on the top side of the device. Measurements are made once a minute (default, can be changed by configuration). The device starts seeking any other nearby devices having the same preprogrammed Wirepas network ID as the device itself.
. INSTALLATION GUIDELINES The device B cover has a double-sided tape which can be used for attachment; remove the cover tape and attach the device to the desired position for distance measurement. The surface for attachment needs to be flat and clean. Press the device from both sides for 5 seconds to make sure that the tape is correctly attached into the surface.
The device operates with fresh Varta Industrial batteries typically for more than 2 years (this time depends heavily on the configuration used for measurement and reporting intervals). If there is a need to change the batteries, spread the side of the A cover gently as shown in the picture below. Be careful while opening the cover that locking snaps don’t break. Remove the B cover, remove the batteries and place new batteries as described earlier.
If the device is already attached to some surface, opening needs to be performed with a special tool: The tool can be ordered from Haltian Products Oy.
The device can also be ordered with batteries pre-installed. In this case just pull out the tape disconnecting batteries in order to power on the device. 4. PRECAUTIONS - TSD2 is intended for indoor use only and shall not be exposed to rain. The operating temperature range for the device is -20…+50 °C. - Remove the batteries from the TSD2 device if you are taking it inside an aeroplane (unless you have the pre-installed pull-out tape still in place).
- Do not short-circuit batteries. Do not try to charge primary batteries. Do not open or disassemble batteries. Batteries should be stored in a dry place and at room temperature. Avoid large temperature changes and direct sunlight. At higher temperature the electrical performance of the batteries may be reduced. - Keep batteries away from children. 5. LEGAL NOTICES Hereby, Haltian Products Oy declares that the radio equipment type TSD2 is in compliance with Directive 2014/53/EU.
FCC REQUIREMENTS FOR OPERATION IN THE UNITED STATES FCC Information for the User This product does not contain any user serviceable components and is to be used with approved, internal antennas only. Any product changes of modifications will invalidate all applicable regulatory certifications and approvals. FCC Guidelines for human Exposure This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This device complies with Part 15 Rules. Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept any interference received, including interference that may cause undesired operation. FCC Radio Frequency Interference Warnings & Instructions This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Ce dispositif est conforme à la nor me RSS-247 d'Industrie Canada applicable aux appareils radio exempts de licence. Son fonctionnement est sujet aux deux conditions suivantes: (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable Radiation Exposure Statement : This device complies with ISED radiation exposure limits set forth for an uncontrolled environment.