Installation Guide

ManualsBrandsHalio ManualsElectronicsEnergy Manager for Glass

EM200IG-190805

Energy Manager

EM200

Installation Guide

INTRODUCTION

Halio Energy Manager stores energy and delivers the

instantaneous peak power needed for fast glass tinting, then

automatically scales to operating the system at low standby

power levels.

INSTALLATION WARNINGS

WARNING / ATTENTION

Read the Energy Manager Safety Guide before attempting to

install this product.

Lisez le Guide de sécurité du gestionnaire d’énergie avant de

tenter d’installer ce produit.

WARNING / ATTENTION

Install in accordance with all NEC and local electrical codes.

Installez conformément à tous les codes électriques NEC et

locaux.

WARNING / ATTENTION

Failure to turn Halio System Power Disconnect OFF before

installing Halio System Power Supply is a hazardous situation

that could result in death or serious injury.

Omettre de couper l'alimentation du système Halio avant

d'installer l'alimentation du système Halio est une situation

dangereuse pouvant entraîner la mort ou des blessures graves.

CAUTION! / MISE EN GARDE

To maintain compliance with FCC’s RF exposure guidelines,

place the product at least 20 cm (7.9 in) away from nearby

persons.

Pour rester conforme aux directives de la FCC en matière

d’exposition aux radiofréquences, placez le produit à une

distance minimale de 20 cm des personnes à proximité.

CAUTION! / MISE EN GARDE

Installation should be installed only by trained Halio installers.

L'installation ne doit être installée que par des installateurs

Halio qualifiés

CAUTION! / MISE EN GARDE

Energy Manager is only for use as part of the Halio system.

Energy Manager est uniquement destiné à être utilisé avec le

système Halio.

PREREQUISITES TO INSTALLATION

Before installing Halio Energy Manager, ensure the following

prerequisites have been met.

 Halio System Power Disconnect has been installed and

connected to the building’s power mains.

 Halio System Power Supply has been installed and

connected to Halio Power Disconnect Switch, and its

48 VDC power output cable has been routed into the

Component Cabinet and remains unterminated.

 Halio Component Cabinet has been installed and

connected to the outputs from the Halio System

Power Supply.

INSTALL ENERGY MANAGER

To install Energy Manager:

1. Turn the Halio System Power Disconnect dial for this Halio

Component Cabinet to the OFF position.

Summary of content (4 pages)

PAGE 1
Energy Manager EM200 Installation Guide CAUTION! / MISE EN GARDE Installation should be installed only by trained Halio installers. L'installation ne doit être installée que par des installateurs Halio qualifiés CAUTION! / MISE EN GARDE Energy Manager is only for use as part of the Halio system. Energy Manager est uniquement destiné à être utilisé avec le système Halio. PREREQUISITES TO INSTALLATION Before installing Halio Energy Manager, ensure the following prerequisites have been met.
PAGE 2
. 3. In the Halio Component Cabinet, center the Energy Manager over the set of 4 pre-drilled holes provided.  If this is the first or only Energy Manager in this cabinet, use the pre-drilled holes located just above the terminal block (as pictured below).  If this is the second or third Energy Manager in this cabinet, use an addition set of pre-drilled holes located higher in the cabinet. 4.
PAGE 3
7. 8. Plug the other end of Energy Manager Power Input Cable (with the pre-wired connector plug) into the power input port on the right side of Energy Manager. Turn the Halio System Power Disconnect dial for the Halio Components Cabinet to the ON position. LED Status Key No.
PAGE 4
5. 6. In the virtual cabinet, press the plus sign (+) next to the bottom open slot reserved for Energy Manager. This begins the virtual Energy Manager installation. Follow the in-app instructions to finish the virtual installation and commission this Energy Manager. When prompted to do so: a. b. c. Scan the barcode on the side of the installed Energy Manager. Press the Setup button firmly. (The Setup button is the depression on the right side of Energy Manager.