Installation Instructions

Installation Instructions
Built-In Dishwasher
If you have questions, call Haier Appliances at 877-337-3639 or visit our website at:
haierappliances.com. In Canada, please call 800.561.3344.
READ CAREFULLY
KEEP THESE INSTRUCTIONS
FOR YOUR SAFETY
Read and observe all WARNINGS and CAUTIONS shown
throughout these instructions.
While performing installations described in this
booklet, gloves and safety glasses or goggles should be
worn.
IMPORTANT – Observe all governing codes and
ordinances.
• Note to Installer – Be sure to leave these instructions
for the consumer’s and local inspector’s use.
• Note to Consumer – Keep these instructions with your
Owner’s Manual for future reference.
• Skill Level – Installation of this dishwasher requires
basic mechanical, electrical and plumbing skills.
Proper installation is the responsibility of the
installer. Product failure due to improper installation is
not covered under the Haier Appliances Warranty. See
Warranty information.
• Completion Time – 1 to 3 Hours. New installations
require more time than replacement installations.
IMPORTANT – The dishwasher MUST be installed to
allow for future removal from the enclosure if service is
required.
Care should be exercised when the appliance is installed or
removed, to reduce the likelihood of damage to the power
supply cord.
If you received a damaged dishwasher, you should
immediately contact your dealer or builder.
Optional Accessories – See the Owner’s Manual for
available custom panel kits.
Your dishwasher is a water heating appliance.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• Remove all power leading to the appliance from the circuit
breaker or fuse box before beginning installation. Failure to
do so can result in a risk of electrical shock.
• To reduce the risk of electric shock, fire, or injury to persons,
the installer must ensure that the dishwasher is completely
enclosed at the time of installation.
• The improper connection of the equipment grounding
conductor can result in a risk of electric shock. Check
with a qualified electrician or service representative if
you are in doubt that the appliance is properly grounded.
If house wiring is not 2-wire with ground, a ground must
be by the installer. When house wiring is aluminum,
be sure to use UL-Listed anti-oxidant compound and
aluminum-to-copper connectors.
• To reduce the risk of electric shock, fire, or injury to persons,
the installer should check to ensure that wires are not pinched
or damaged, the house wiring is attached to the junction box
bracket through a strain relief, and all electrical connections
made at the time of install (wire nuts) are contained inside of
the junction box cover.
• Do not use an extension cord or adapter plug with this
appliance.
WARNING
• Be sure to leave complete literature package, these Installation
Instructions and product samples and/or coupons with the
consumer.
NOTE: Product improvement is a continuing endeavor at
Haier Appliances. Therefore, materials, appearance and
specifications are subject to change without notice.
31-31591 03-18 GEA
0120501699A