Cube Storage Assembly Instructions Please keep for future reference 609/1460 Lawmaker 609/5693 Dimensions Width 80cm Depth 24cm Height 67 .
/\ Safety and Care Advice Important Please read these instructions fully before starting assembly * Check you have all the components and tools listed on page 2 and 3. * Remove all fittings from the plastic bags and separate them into their groups. « Keep children and animals away from the work area, small parts could choke if swallowed. « Make sure you have enough space fo layout the parts before starting. « Do not stand or put weight on the panels during assembly, this could cause damage.
Components Panels Back (338x169cm) [[1] Top (80x 240m) Side x 4 (23.8 x 16.9cm) ° ° [2] Top shelf (80 x 24cm) support x 2 (23.6 x 16.90m) [3] Bottom shelf (80 x 24cm) Support x 2 (23.8 x 16.9cm) [4] Bottom (80 x 24cm) o o Front 9.5cm) Side support 9.
g # you have damaged or missing components, Com opponents Fitch NGS cite Customer Helpline: 08456 400800 Please check you have all the fittings listed below Note: The quantities below are the comet amount to complete the assembly. In some cases more fittings may be supplied than are required.
Assembly Instructions EXILE Fitting the has a: Caution: Always check the assembly method is correct before applying grue. a: Place a small amount of glue @ into the dowel holes. Insert dowels O into side front panes{ 9 | b: Pace a small amount of gluey @ into the dowel holes Attach the front panels| 8 loon the side supports[10].
Fitting the bottom panel a; Use screws (o fix side panels[ 6 Onto the unit b: Pace a small amount of iguana @ into the dowel holes. Insert dowels ()into side panels[ 6 |and support , then attach support onto the unit Titling the bottom shelf a: Screw socking pins(® into bottom shelf[3 ] Insert locking pins as far as shown.
Step 3 continued b: Pace a snail amount of glue @ into the dowel holes. Attach bottom shelf[ 3 Onto the unit Use a screwdriver to turn locking nuts () clockwise 1o lock, then use plastic plugs 1o cover the locking nuts. b: Place a small amount of glue 3 into the dowel holes. Insert dowels @ into left support| 8 |, then attach left support| 8 onto bottom shelf{ 3] Insert dowels () into right support[ 8 Jan back panel[5 |, then attach right support] 8 |and back panel[ 5 onto the unit.
Fitting the top shelf a: Screw locking pins @ into top shelf[ 2] Insert locking pins as far as shown Use screws (¥to fix side %els onto top shelf b: Pace a small amount of guile ( into the dowel holes. Attach top sheaf[ 2 Onto the unit. Insert dowels Q) into support[ 7], then attach support| 7 onto the unit. Use a screwdriver fo turn locking nuts () clockwise to lock. then use plastic plugs 1o cover the locking nuts. €: Place a small amount of glue @ into the dowel holes, Insert dowels O info the unit.
Fitting the top panel a: Screw locking pins © into top panel[ 1| Insert locking pins as far as b: Place a snail amount of glue @ into the dowel holes. Attach top panel[1] onto the unit Use a screwdriver {o turn locking nuts @ clockwise to lock. then use plastic cover hocking nuts. Assembly is complete.